Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This mini LED light gives you bright, reliable visibility without the high power draw. It uses three red LEDs that only pull 0.06 amps at 12.8 volts, so you get strong illumination while keeping your system efficient. Compared to old incandescent bulbs, these LEDs shine brighter, last up to 50 times longer, and don’t need bulb changes or worry about brittle filaments.
If your trailer ever hits rain or water, this light is built to handle it. The polycarbonate lens and housing are sonically sealed into a single waterproof unit, keeping moisture out and protecting the diodes from corrosion. It’s fully submersible, so you can launch or pull your trailer through wet environments without worrying about shorting out your lights.
This light throws a wide 180-degree beam pattern for clear visibility from the front and side. The PC rating means it can serve as both a clearance and side marker light when properly mounted, adding safety by making your trailer easier to see from multiple angles. With this setup, you get improved awareness for both daytime and nighttime travel.
At just 2-1/2" long by 1-1/8" tall and 5/8" deep, the low-profile rectangular housing fits into tight spots without sticking out. It surface mounts flat against your trailer—no cutout required—and can be installed horizontally or vertically with standard hardware. The 2-wire pigtail makes wiring easy: one lead for power and one for ground.
The light’s polycarbonate housing and lens stand up to vibration, shock, and daily wear. Inside, surface-mount technology keeps the LED circuit board stable and distributes heat evenly for longer life. It’s a tough little light designed for years of dependable use, backed by a lifetime warranty on the LEDs.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're taking a look at the Optronics Mini LED Trailer Clearance and Sidemarker Light.This small trailer light functions as both a clearance light and sidemarker light when properly mounted. It is SAE and Department of Transportation compliant.It features a sonically sealed design. So, that means that it is completely waterproof. It is submersible.It is an LED system. LED has been a great replacement for incandescent lights. They last longer.
They burn brighter. They're more efficient. With LEDs, you don't have to worry about replacing bulbs or worry about brittle filaments.It has a nice red lens for looking at a polycarbonate lens and housing for strength and durability.It's a direct surface mount installation. Mounting hardware not included, but it mounts directly on the surface of the trailer. Can be mounted horizontally or vertically, whichever works best for your application.It's a two wire design.
So our white wire is our ground wire. Black wire is our power wire. It is P2PC rated.We're going to go over the measurements real quick and then we'll hook it up to power so you can see what it looks like with power running to it.Going edge to edge, this direction, it measures about two and a half inches. Top to bottom, measures about one and one-sixteenth to one and one-eighth inches. The overall depth is only about five-eighths of an inch deep or thick.
So it's a nice low profile design. The mount holes on the unit are separated on center by one and three-quarter inches.We're going to go ahead and hook it up to power. That way you can see what it looks like with power running to it. We'll also turn off our overhead lights, so you can see it in a lower light setting.This light sends out a nice, clear, consistent signal. It features a multi-diode design.
So the unit actually has three LEDs internally. So the multi-diode design really helps optimize the overall light output. The power draw at 12.8 volts is 0.06 amps and Optronics puts a lifetime warranty on the LEDs.That's going to do it for today's look at the Mini LED Trailer Clearance and Sidemarker Light.
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Brooke M.
2/25/2025
Thanks for the photo as well as all the tips about install. Its nice knowing what other peoples first hand experience was. Thanks!