Is There a 60 Inch by 8 Inch Steel Backing Plate for Trailer Fenders
Updated 07/22/2021 | Published 07/19/2021
Products Featured in This Question
Question:
Fender backing for tandem. I need 60”x8”
asked by: Chris
0
Expert Reply:
I have a solution for you, but we do not offer that particular size of the backing plates for etrailer Trailer Fenders. However, you can use the Backing Plate for Tandem Axle Trailer Fender - Steel - 69" x 12" # HP72FR and cut to the size you need. This backing plate is made from 16 gauge steel, so you could cut this with a hand shear in most cases.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Backing Plate for Tandem Axle Trailer Fender - Steel - 68-7/8" Long x 12" Tall
- Accessories and Parts
- Trailer Fenders
- Fender Back
- 12 Inch Wide
- 68 Inch Long
- etrailer
more information >
Continue Researching
- Q&A: Recommended Upgraded Sway Bars for a 2001 Ford F-350 Dually
- Q&A: Installation of Emergency Break Away Cable Repair Kit for Dexter Axle A-60 Brake Actuators
- Q&A: Does the Band Around the Spring Pack Go Forward When Installing Leaf Springs?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Replacement For Parallax Model 555 Power Converter
- Q&A: Availability of Back Plate for etrailer Single Axle Trailer Fender # HP66VR
- Q&A: Trostel 324-216-8 Replacement Grease Seal
- Q&A: What is the Weight Capacity of the etrailer Swivel Jack w/ Bolt-On Mounting Plate
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Mount a Truck Bed Camper
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide