Replaces the valves for your holding tanks. Valve passages allow wastewater to travel freely when valves are open. 72" Flexible cable lets you install handle where you want it. Valve bodies, cables, seals, and hardware included.
Features:
To install, remove the broken waste valve and seals from your holding tank. Then place the included seals on the flange fittings and position the new valve body. Tighten the provided hardware to complete installation.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at the Valterra Waste Valve Bodies with the 72 inch long flexible cables for your RV black water and gray water tanks. Now, these are replacement valves for your RV's black water and gray water tank. You can see this smaller one is a 1 1/2 inch diameter opening, and the larger one is the three inch diameter opening. Both of those will allow your waste water to travel freely when the valve is open, and then when you don't need it open, you just turn your handle, and that'll close the valve. Now, this part will include everything laid out here on the table, it includes the three inch valve body with the seals and the hardware to install it, comes with the 1 1/2 inch valve body with, again, the seals and the hardware, comes with two of the 72 inch long flexible cables, and then it comes with two of the aluminum mounting brackets with the hardware for installation.
Now the cables, these are 72 inches long, they are flexible, so they'll let you install this valve handle where you want them. The cable will allow the handle to be converted from a hard to access location to just a simple push and pull placement like the control access compartment of your RV. The inner wire on this cable is stainless steel construction. Now, they do also offer these included aluminum mounting brackets, which will allow you to mount the handles to an RV side wall if need be, if there's no room in your access compartment, and I just wanna pop up an insert and show you. You would attach the handle right there if you look at the insert, shows the handle attached, and then that can be attached to the side wall on your RV, and then you can operate the valve from that position.
I wanna give you some dimensions on this. We're gonna go over the first one, the small valve, which is this one right here, the dimension on that, the length of it is gonna be right at 10 1/4 inches, width of it is 3 1/4 inches, and the depth at the widest point is 1 1/2 inches. Now, if we go to the larger three inch one, we will get the tape measure out for that one. That one you're gonna be looking at total length of about 14 1/2 inches, the width on it, about 4 3/8 inches, and the depth will be the same at the widest point, 1 1/2 inches. But that should do it for the review on the Valterra Waste Valve Bodies with the 72 inch long flexible cables for the RV black water and gray water tanks..
Came earlier than expected.
Do you have a question about this RV Waste Valve?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.