Kwikee RV Cargo Slides - LC370761

Love to DIY? Use this rail kit, a trim kit (sold separately), and plywood bottom (not included) to build a tray that perfectly fits your cargo compartment. And you can slide these rails out from either side of your RV to grab your camping gear.

Features:

• DIY a complete slide-out tray - Pair this rail kit with a trim kit (sold separately) and plywood bottom (not included)
  • Store and retrieve camping gear - Perfect for tools, power cords, and hiking boots
  • Customize your tray - Opt for a full-length tray or dividers for smaller items
• Great for pass-through storage compartments - Rails slide out from either side of your RV
• Lockable when stowed - Spring-loaded latches prevent the rails from sliding during travel
• Resists rust during rainy weather - Durable steel has a powder-coat finish
• Easy to install - Rails bolt onto the floor of your cargo compartment
• Buy American - Rail kit is made in the USA

Specs:

• Fits: RV cargo compartments at least 80" long
• Tray weight capacity (when fully assembled and installed): 800 lbs
• Overall exterior dimensions (per assembled rail): 3-1/2" wide x 6" tall
  • Depth when fully stowed: 80"
  • Depth when fully extended: 127-3/4"
• Mounting hole spacing (per assembled rail):
  • Between 2 holes: 17-1/2"
  • Between the holes on the ends: 70-3/4"
• 1-Year warranty

Additional parts you may need:

• 2x4s (Not included) raise the rails so they can adequately clear your compartment door
• Wood screws and 5/16" hardware (not included) are required for installation

Pair this rail kit with a tray trim kit (sold separately) and a carpet-covered plywood bottom (not included) to create a complete slide-out tray for the cargo compartment in your RV or camper. This is perfect for you if you're a DIY'er or if you have a uniquely shaped compartment that wouldn't fit a pre-made tray. You can slide the rails out from either side so you can easily grab camping gear without needing to crawl into your cluttered or cramped compartment.

Determining Which Rail Kit You Need

To figure out which rail kit you need, measure the overall inside length of your cargo compartment. The measurement you get is the maximum length the rail kit should be, though you may need to go with slightly smaller rails to account for any potential clearance issues. For example, for this 80" rail kit, your cargo compartment shouldn't be shorter than 80" long. If your cargo compartment is shorter or longer, please reference the table below.

Length of Cargo Compartment	Rail Kit You Need
42"	LC370782 (42")
48"	LC370783 (48")
54"	LC370785 (54")
60"	LC370787 (60")
80"	LC370761 (80")
90"	LC370762 (90")

Determining Which Tray Trim Kit You Need:

The trim kit needed to complete your SuperSlide II is sold separately. To determine which trim kit you need, measure the width of your cargo compartment opening, and then subtract 4. This ensures that the tray would have the proper clearance as it slides in and out.

Width of Cargo Compartment	Trim Kit You Need
27"	LC370674 (23")
28"	LC370676 (24")
31"	LC370678 (27")
34"	LC370680 (30")
36"	LC370682 (32")
37"	LC370684 (33")
40"	LC370688 (36")
41"	LC370690 (37")
43"	LC370692 (39")
48"	LC370755 (44")
52"	LC370757 (48")
55"	LC370759 (51")

370761 Lippert Rail Kit for Quickee Super Slide 2 RV Sliding Storage Tray Assembly - 80" Deep

Alternate part number: 905849800