Need to fix or join a 3/4' water line in your RV? This Flair-It straight coupler makes repairs fast. Just hand-tighten for a leak resistant seal and get your plumbing back in shape with no special tools.
Need to fix a faulty section of 3/4" pipe in your RV's plumbing system? The Flair-It straight coupler makes repairs and upgrades easy. Just cut the pipe, slide on the nut, push the pipe ends onto the barbs, and hand-tighten the compression nuts for a leak resistant seal. No tools required, so you can get the job done fast and get back on the road. If attaching the 3/4" barbed end to a gray PB pipe, you must use a Flair-It PB adapter sleeve (FL72VR sold separately).
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, there, I'm Michael with etrailer.com. Today, we're gonna take a quick look at this Flare-It pex adapter fitting. This adapter is going to have two of these 3/4-inch barbed connections that will allow you to connect pipes in the hoses in your RV fresh water plumbing system. Whether you are needing to repair leaky connections or install new lines, this is going to work with your pex pipes, the old gray PB pipes and polyvinyl tubing. Having the two 3/4-inch barbed connections is going to allow you to connect two hoses or tubes with a 3/4-inch inner diameter. The barbed connector with the compression end means that you're not gonna have to worry about using any tools to get this installed.
So basically, you'll just put this compression end on your hose and then you'll put the barbed in inside the hose. And that might take a little bit of doing, might have to wiggle it in place and apply some pressure, but you can do it by hand. And then once you have that in place, then you'll just tighten this down. And I know I just did one of these a few minutes ago. Getting that tightened down by hand is gonna be plenty sufficient.
It was a very snug fit. I actually took, using a couple of tools to get it undone, but just tighten it down by hand is gonna create a nice, solid connection for you. This does have a polyoxymethylene construction, so it is gonna be very durable and resistant to stress cracking. So will hold up well for you and connect those two hoses or tubes with that 3/4-inch inner diameter. And that completes our look for today.
Again, I'm Michael with etrailer.com. Thanks for watching.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.





Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.