A big lithium house battery bank needs more than a trickle of power. This Victron charger puts up to 70A back into it as you drive, so you pull into camp with more power ready for the night.
Your RV or boat can use a lot of house battery power before the next travel day. The Orion XS charges your 12V house bank from the engine alternator at up to 70A, with up to 1,000W of output. Its 98.5% maximum efficiency reduces wasted energy, and dual cooling fans support full rated power at temperatures up to 104°F with adequate airflow. That is more charging potential during the miles you are already driving.
More charging current is useful only if your alternator, wiring, and batteries can handle it. Set both input and output current from 1A to 70A in 0.1A increments to match your system. The Orion XS works with conventional and smart alternators, including variable-voltage models. Built-in engine shutdown detection stops normal charging when the engine is off, while adjustable input-voltage lockout adds protection for your starting battery.
Lithium and lead-acid house batteries do not all charge alike. Choose from 8 battery presets or customize the charging profile through the VictronConnect app. The adaptive 4-stage charger supports lithium, AGM, gel, and flooded batteries, with configurable low-temperature charging shutdown for lithium. Bluetooth also lets you check charging status from your phone. Compatible Victron devices can share voltage and temperature data through VE.Smart Networking, while a GX device connected through VE.Direct adds remote monitoring.
If your starting battery runs low, emergency reverse charging can transfer energy from your house battery back to it. Start the function through VictronConnect, and the Orion XS can supply up to 35A for 15 minutes before a 5-minute period for attempting to start the engine. This feature requires Orion XS firmware v1.15 and VictronConnect v6.43 or later, and it cannot revive a failed starting battery.
This 70A model has 2 fans on its underside, so the mounting surface must leave the air inlet open. Install it inside a dry, ventilated compartment with at least 10 cm of clearance around the unit. The charger is rated IP20 overall, even though its internal electronics are enclosed to IP65, and its non-isolated design is intended for systems that share a common negative connection.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Ratings & Reviews
Do you have a question about this Battery Charger?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.



Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.