2015 Fifth Wheel Hitch

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…

Hey Jerry, GM moved the placement of their puck systems starting with 2020 models so you are correct that the pucks would have the hitch not sit directly over the axle. GM did the math and made sure that this placement wouldn't adversely affect…

Thank you for the photo of your 2016 Ram 3500's bed rail which sits 59-inches above ground. You are correct that the recommended minimum clearance between a bed rail and the underside of the trailer's overhang is 5 to 6-inches, as shown in…

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…

Hi Bob; is your Patriot the slider #BWRVK3270 you looked at or the fixed #BWRVK3255? I know you said fixed mount hitch but since you looked at the slider I want to be sure. If it is the fixed hitch you can use the Adapter Rails for Curt 5th Wheel…

Hey Carter, thanks for reaching out! The GM trucks with the 6-1/2' bed can use a stationary hitch as long as the 5th wheel trailer has a tapered nose. For your 2025 GMC Sierra 2500 I recommend using the PullRite OEX SuperLite #PUL96ZR for a few…

Hey Craig, yes the leg kit part #e89PR that you referenced will work to adapt the head of a Curt A20 hitch to fit the OEM pucks of your 2024 Chevy Silverado 3500. How'd you like your A20 hitch?

Hey Bob! It sounds like you have industry standard rails in there right now. Do they look like the picture below and match those measurements? If so, you can use the Curt E16 #C95DR. However, I recommend getting the B&W Patriot 5th Wheel Trailer…