Tail Lights Go Dim or Out When Brakes are Applied
Updated 09/09/2020 | Published 01/04/2010
Question:
I rewired my trailer and now have the following problem. Left and right blinkers work as do running lights, however when the brakes are applied on the vehicle the tail lights go out. This is small utility trailer connected with 4 pole flat plug to 2004 ford ranger with factory tow package.
asked by: Richard
Expert Reply:
It sounds like you have a bad ground connection. If all ground connections are not making good contact to bare metal, when the brake pedal is pressed and the tail lights are on, the increased amperage draw will make this problem show up.
You will need to check all of the ground connections especially where the taillights are mounted to the trailer frame, and where the light brackets are mounted if they are bolted to the frame. If a plastic license plate holder is mounted between the left side taillight and the trailer frame this could be the problem.
Once you have all of ground connections checked, if the problem persists, you will need to check for a broken pinched or frayed wire on the trailer somewhere. If this is not the case then you will need to use a circuit tester, item # PTW2993 if needed, and make sure your wire connections have been properly made at the taillights.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Complete Breakdown of the Timbren Suspension Enhancement System-TDRTT1500
- Video: Install: Timbren Suspension Enhancement System on a 2017 Ram 1500
- Video: 2013 Ram 1500 Timbren Suspension Enhancement System: Complete Installation
- Shop: Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Shop: Firestone Coil-to-Air-Spring Conversion Kit - Rear Axle
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Lights Dimming When Brakes are Applied with Trailer Connected 2012 Toyota Tacoma
- Q&A: Why Would Peak Back Up Camera Turn Off When Brakes are Applied
- Video: Air Lift 1000 Heavy Duty Air Helper Springs for Coil Springs Spec Review
- Q&A: Troubleshooting Trailer Lights Going Out When the Brakes are Applied After Trailer Light Kit Install
- Shop: Air Lift 1000 Heavy Duty Air Helper Springs for Coil Springs - Rear
- Shop: Aluminum Viking Series Valhalla Trailer Wheel - 15" x 5" - 5 on 4-1/2 - Silver Spoke
- Q&A: Parts Needed to Install Brake Controller in 1997 Dodge Ram
- Video: Installing the Air Lift LoadLifter 5000 Air Helper Springs on your 2021 Ram 1500
- Shop: Air Lift WirelessONE Compressor System for Air Helper Springs - Remote - Bluetooth - EZ Mount
- Shop: Air Lift Air Shock Controller Compressor System for Air Shock Absorbers - 100 psi
- Shop: Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers - Rear Axle
- Q&A: Running Lights Turn Off When Brake Pedal is Applied
- Video: Breaking Down the Karrier ST175/80R13 Radial Trailer Tire with 13" Aluminum Wheel
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
on Automotive Tools
Steven P.
9/7/2020
My 97 Tahoe when I hook up my trailer all the lights work fine until I turn on headlights then the trailer lights dim. Thanks,