How to Wire Replacement Switch for Solera 18V Power RV Awning

Question

Question:

My wires coming out of the awning is red and blue. The wires on the switch is red/white and white. What goes where?

asked by: ESSIE S

0

Expert Reply:

I took a look around at the Lippert literature but I'm having trouble finding a wiring diagram for the Replacement Switch for Solera 18V Power RV Awning # LC644584. The good news is that these wires are connected to the head so you can just connect them to the wires you found and see if the awning operates correctly. If it retracts when it should extend then you just need to switch the wires to get the correct functions.

expert reply by: Jon G

0

Answer 1

We have the Solera 12V XL Power RV Awning - 17' Wide - Extra-Long 9'8" Projection #LCV000334961-362243 which is 17 feet long and would work great on your Keystone. It's a powered awning which means you'd be able to extend and…

view full answer...

Answer 2

I attached a wiring diagram for the Solera Power Awning Switch Kit #LC285500 for you to check out.

view full answer...

Answer 3

To get power to the controller of your Solera Smart Arm 12V Power RV Awning part #LC759404, you need to tap into an existing circuit, or run a power wire from the battery with an inline fuse holder, and a 15 amp fuse, like part #SWC9538, and part…

view full answer...

Answer 4

Hey Dan, for your 2024 Ford F-350 that has the OEM pucks the correct Pullrite sliding hitch you need is the part #PUL73RR. The #PUL63RR fits the standard above bed fifth wheel rails that are 22 inches apart on center. What fifth wheel do you have?

view full answer...

Answer 5

I reached out to Lippert for help with their Solera 18V Electric RV Awning Conversion Kit #LC434730. While they do not have a video or instructions which address removing or installing the new Battery #LC387959 I was instructed the retainers holding…

view full answer...

Answer 6

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 7

Hey Dave, the battery is supposed to be good for 20-25 retractions before needing charged. If yours won't hold a charge it does sound like it needs to be replaced which we have with the part #LC387959.

view full answer...

Answer 8

The rooftop condenser unit can be replaced with a model like the Advent Air Replacement RV Air Conditioner for Dometic Setup #ACDOM150, you'll just want to determine the connector style for the current unit. It will have either a 6-pin or 9-pin…

view full answer...

Answer 9

The Replacement Solera Awning Switch #LC285500 has 4 wires: white, red, black and blue. I have attached the diagram below which will show you the function of each wire. As far as the white and blue wires on your camper, wire color is not always…

view full answer...

Answer 10

The Solera switch part #LC285500 that you referenced was designed to fit all Solera power awnings so it would work well to give you an inside switch to extend and retract. This would not affect the batteries ability to charge either.

view full answer...

How to Wire Replacement Switch for Solera 18V Power RV Awning

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching