Replacement For UFP A-60/A-75 Disc Brake Actuator

Question

Question:

I have a UFP A-60/A-75 actuator that has gone bad [the brakes wont release]. Is there a rebuild kit for these actuators or do I need to buy a new one. The trailer is a single axle with disc brakes.

asked by: Tom P

1

Helpful Expert Reply:

There is not a rebuild kit so you would need to replace your UFP A-60/A-75 disc brake actuator, with the correct one depending on if you have a 3" x 5" or 3" x 4" straight tongue:

- 3" x 5" Straight Tongue: Dexter DX7.5L A-60 Brake Actuator # DX56FR

- 3" x 4" Straight Tongue: Dexter DX7.5L A-60 Brake Actuator # DX29FR

expert reply by: Kyle S

1

Answer 1

We can get you a replacement for your TDE LP75 disc brake actuator; that's a 7,500 lb actuator that accepts a 2" hitch ball, and the correct option will depend on if your trailer tongue is 3" wide x 4" tall or 3" wide x…

view full answer...

Answer 2

Yes, you will want to flush out all your old dirty brake fluid from your lines and master cylinder. You can use the Hand Vacuum Pump Brake Bleeder #PTW87030 to do this but in my experience I find it best to use the manual method using the 2x4 to be…

view full answer...

Answer 3

Hey Ryan, yeah you're right TDE is no longer a thing and unfortunately we don't carry a replacement reverse solenoid for that actuator so at this moment your best bet would be to replace the entire thing with the Dexter DX7.5L A-60 Brake…

view full answer...

Answer 4

Hey Bruce, you'd want to make sure the tongue of your trailer is 3 inch wide to verify for sure that the Dexter actuator part #DX29FR fits. This is also designed for 2 inch hitch balls and the brake type needs to be disc.

view full answer...

Answer 5

Len, the banging that you're describing is absolutely a common symptom of a bad shock component, so all you need to fix it is to replace it with the Replacement Shock Absorber Spring Kit for Dexter Brake Actuators #TK71-758-00.

view full answer...

Answer 6

The most like replacement option we have for the UFP A-60 Hydraulic Brake Actuator for Disc Brakes is the Dexter DX7.5L A-60 Brake Actuator with Electric Lockout part #DX56FR. This is a bolt-on actuator designed for use with disc brakes. Please note,…

view full answer...

Answer 7

We do have replacement hydraulic actuators for your UFP A60 boat trailer actuator: If the actuator mounts on top of the trailer frame use part #DX89FR, but if it mounts inside of the trailer frame use part #DX29FR instead. These disc brake actuators…

view full answer...

Answer 8

The Replacement Shock Absorber Spring Kit #TK71-758-00 is the correct shock for your UFP Surge Brake Actuator. The picture you included does not specify if it is for a disc or drum brake set, so I have found both for you to choose from. Disc Brake…

view full answer...

Answer 9

I assume you have disc brakes since you mentioned an electric lockout, and we do have an A-60 actuator; the correct one will just depend on if you have a 3" x 5" (most likely) or 3" x 4" straight tongue: - 3" x 5":…

view full answer...

Answer 10

The Trailer Coupler Lock #e98887 will work with a UFP A-60 coupler like your Dexter A-60 #DX56FR. The product picture for this lock shows it being used on an A-60.

view full answer...

Answer 11

The correct replacement actuator for your UFP 34034 is the Dexter DX7.5L A-60 part #DX56FR.

view full answer...

Answer 12

The Dexter DX7.5L A-60 Brake Actuator w Electric Lockout #DX29FR would work for you as it's for disc brake trailers and can fit a 3 inch wide trailer tongue like you have.

view full answer...

Replacement For UFP A-60/A-75 Disc Brake Actuator

Product Page this Question was Asked From

Continue Researching