Rear Anchor Installation Instructions For HappiJack Truck-Mounted Tie Downs

Updated 10/15/2021 | Published 10/14/2021

Products Featured in This Question

Replacement Anchor Bolt for HappiJac Truck-Mounted Camper Tie-Downs - Qty 1

(15)

$31.47

HappiJac Camper Tie-Downs - Custom Bed and Bumper Mount - Front and Rear

(217)

$209.33

Question:

Can you show a video of the anchor bolt tie-downs being installed into the bumpers? I dont understand the point of the gap washer. And where on the bumper do you drill the hole for the bolt?

asked by: Kenneth P

Helpful Expert Reply:

To install the Replacement Anchor Bolt for HappiJac Truck # LC182852 for the HappiJac Truck-Mounted Camper Tie-Downs # LC182861 follow the instructions below and use the reference picture attached:

1. You'll start by marking a center point from left to right and 1 1/8" from bottom to inset on the rear bumper.

2. Next, you will center punch this mark and pilot an 1/8" hole.

3. Then, step the bit up to 1/2".

4. Finally, you will now install the anchor bolt with the flat surfaces of the bolt horizontal.