Replacement Filter for Ventline Range Hood CC316-1

Question

Question:

We have an RV with range hood that says CC316-1, we would like to replace the filter. What is the filter part number and how much is one?

asked by: Gena

0

Expert Reply:

I was able to find some info on your older Ventline Range Hood CC316-1 and the correct replacement grease filter is the part # BCC0246-00.

expert reply by: Jameson C

0

Answer 1

The CC316-01 number you referred to is the original part number of the fan motor. Is it a replacement fan blade or motor you're needing? If that's the case, you'd use the #BVD0218-00-R replacement motor. If you were needing a replacement…

view full answer...

Answer 2

I did some research on the Bargman L-300 lock that you mentioned in your question, and it appears that these have not been made in a long time. Specific replacement parts for this particular line are no longer produced. If you are needing to replace…

view full answer...

Answer 3

The replacement motor for the Greystone RV Range Hood with Light - 12V - 24" Wide - Black Item #324-000087 is the Replacement 12-Volt DC Fan Motor for Ventline RV Range Hood Item #BVD0218-00. If you also need to replace the fan blade the correct…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Dan, for your 2024 Ford F-350 that has the OEM pucks the correct Pullrite sliding hitch you need is the part #PUL73RR. The #PUL63RR fits the standard above bed fifth wheel rails that are 22 inches apart on center. What fifth wheel do you have?

view full answer...

Answer 11

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Replacement Filter for Ventline Range Hood CC316-1

Product Page this Question was Asked From

Continue Researching