How To Install the Optronics LED Combination Trailer Tail Lights TLL160RK
Question:
How to I adjust the trailer mounting bolts so the fixture slides onto the bolts and the fixture stays tight to the trailer? I cant figure out how to set the bolt length so the that happens. THe fixture fits loose to the mounting bolts, and falls off when I cross a rough road.
asked by: Kevin J
Helpful Expert Reply:
In order to install the Optronics LED Combination Trailer Tail Lights part # TLL160RK you will first need to drill holes in the trailer or trailer light mounting bracket that align with the mounting holes on the light. The carriage bolts will then slide into the back of the housing on the light and then through the holes on the trailer/light mounting bracket.The flange nuts will then be used to tighten the light to the trailer/light mounting bracket.
I have attached an installation video on these lights for you below. That said, you need to be careful that the carriage bolts seat correctly inside the housing or else it will be very hard to secure the light without it becoming loose.
Product Page this Question was Asked From
Optronics LED Combination Trailer Tail Lights - Submersible - 40 Diodes - Driver and Passenger Side
- Trailer Lights
- Tail Lights
- License Plate
- Rear Clearance
- Rear Reflector
- Side Marker
- Side Reflector
- Stop
- Tail
- Turn
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 8L x 3W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Replacement Taillight Solution for Lens Number S2T216AP2
- Q&A: Can Furrion Chill Cube Be Added To Camper As 3rd AC Unit?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Can Furrion Chill Cube AC Unit Be Used To Replace Coleman Mach AC?
- Q&A: What TorkLift Tie Downs do I Need for My 2022 F-350, and What are the Weights?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Changing the Bulb in the Wesbar Tail Light Capsule
- Q&A: What is the Inner Diameter of the 3,500 lbs Dexter Trailer Idler Hub Assembly?
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)