Power Wire Size for Lippert Power Stabilizer Jack # LC298707
Products Featured in This Question
Question:
What size wire from the battery? Can you wire front and rear to same power wire? Run wire to front switch then carry on to rear switch Or do you need to run separate wires? Do you have to ground back to battery or just to trailer frame? Thanks
asked by: Ken L
Expert Reply:
You will want to use a minimum of 10 gauge wire like # 10-1-1 from the battery to the motor on the Lippert High-Speed Power Stabilizer Jack # LC298707.
I do not recommend running a front and rear stabilizer to the same power wire. Each wire uses a dedicated 20 amp fuse/breaker so running both wires together would trip the fuse and also make it a lot harder to troubleshoot if something were to happen to one of the jacks down the line.
I do recommend grounding the black wire directly to the negative post on your battery to ensure a good connection. I have attached a wiring diagram that you might also find helpful.
Product Page this Question was Asked From
Lippert High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- Electric Jack
- 30 Inch Lift
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Air Lift Universal Air Spring Spacers for LoadLifter 5000 and 7500XL - 2" Lift - Qty 2
- Search Results: air lift vehicle suspension
- Search Results: gen y
- Search Results: air lift spacers
- Video: Installation: B and W Companion Sliding 5th Wheel Hitch w/ Turnoverball for Ram on a 2021 Ram 2500
- Video: B and W Turnoverball Underbed Gooseneck Trailer Hitch Installation - 2022 Chevrolet Silverado 2500
- Video: B and W Ball and Safety Chain Kit Underbed Gooseneck Trailer Hitch Review
- Shop: Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs - Rear Axle
- Shop: B&W Ball and Safety Chain Kit for Ford, GM, Chevy, and Nissan Titan XD Underbed Gooseneck Hitch
- Shop: Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box - Lippert 1116/1716 - 30K GTW - 4.5K TW
- Q&A: Recommended Air Bags and Standard 5th Wheel Hitch for a 2023 GMC Sierra 2500 w/ Factory Prep Package
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Shop: Timbren 1" Spacer For Raised Frame Vehicles - 3/8" Bushing
- Shop: RoadActive Suspension Custom Leaf Spring Enhancement Kit - Heavy Duty
- Video: Timbren Axle-Less Trailer Suspension System Test Course
- Video: Review of Timbren Trailer Leaf Spring Suspension - Silent Ride Suspension - TSR7KS02
- Video: Complete Breakdown of the Timbren Axle-Less Trailer Suspension w/ Idler Hubs
- Search Results: stromberg carlson
- Search Results: anderson trailer jack block
- Video: What to Know About the Stromberg Carlson Base Pad Peak for Scissor and Stabilizer Jacks
- Q&A: Wiring of Switches on Ultra-Fab Power Twin II Electric Stabilizer
- Search Results: nuts
- Search Results: brake nuts
- Q&A: Replacement Parts for Lippert PSX2 Electric Stabilizer
- Q&A: Availability of Heat Strip or Heat Pump for Furrion Chill Cube RV AC
- Article: Performance Chips and Modules
- Q&A: Replacement Jack or Support Arms for Lippert PSx1 Stabilizer
- Q&A: Replacement Motor for Lippert Power Landing Gear assemblies
- Q&A: What are Dimensions of Tubing Used on Draw Tite Hitch 82201
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
on Camper Jacks
