Replacement Bolt-On Fulton Trailer Jack

Question

Question:

I need to replace a Fulton jack on a boat trailer. It has a center bolt, which bolts to a welded bracket on the trailer. Which trailer jacks do you offer that will fit this application?

asked by: Dan O

0

Expert Reply:

Thank you for the photo it was helpful in determining what you need. The replacement would be the Fulton Bolt-Thru Swivel Marine Jack # FXP10W0301 which has a bolt-through mount, 1,200 lb lift capacity and has bracket heights of 12-3/4" retracted and 22-3/4" extended. I've added a link to a video review of this jack for you to look at.

expert reply by: Kyle S

0

click to enlarge

Answer 1

Swapping the mounting hardware on a jack can be done, but it will depend on the specific mounting hardware of the jacks. Shelby jacks and parts are becoming more difficult to locate, so I would recommend replacing your Shelby hardware with something…

view full answer...

Answer 2

We offer weld-on and bolt-on trailer jacks that are similar to the Shelby 5764A jack you wish to replace but the jacks we offer are not exact replacements. We do have a jack that has a mounting plate similar to the Shelby mounting plate., It is part…

view full answer...

Answer 3

The correct replacement for the Fulton Magnum Series Trailer Jack on your trailer is the Fulton Bolt-Thru Swivel Marine Jack part #FXP10W0301 if you have a bolt-thru mounting bracket or part #FTJ120W0301 if you have a snap-ring mounting bracket. I…

view full answer...

Answer 4

We don't have the dimensions of the weld-on mount for your Shelby jack, but it looks similar to the Jack Mounting Bracket for Fulton Marine Jack - Weld-On #P9012-00. That mounting bracket uses a 1/2" bolt with pin holes measuring 3"…

view full answer...

Answer 5

If the trailer is heavy, or the ground is uneven, it will be hard to move regardless of which jack you use but if the bearings are wearing out in the old one then a new one would surely take some strain off the user when moving. I recommend a dual…

view full answer...

Answer 6

The #F500323 that you referenced should work for you. Your TJ507 jack was replaced by the part #FXP10W0301 which the cap has been confirmed as a fit for.

view full answer...

Answer 7

No, I am sorry it does not. I just spoke with Lippert and none of the Curt Helux Shock-Absorbing 5th Wheel Pin Box like item #C73RJ are compatible with gooseneck adapters like the Anderson Ultimate 5th Wheel Hitch. You would need to use a standard…

view full answer...

Answer 8

Yes, since your current Fulton jack is a bolt-thru style, you can use the Fulton XLT Bolt-Thru Swivel Trailer Jack #F26ZR with your current welded on bracket. You just need to remove the jack from the included bolt-on bracket and mount it to your…

view full answer...

Answer 9

In order to determine which hubs you're going to need as a replacement you will need to pull the hubs to see what bearings will fit on your spindle; the bolt pattern is only part of the equation, but still helpful to know. To accomplish this you…

view full answer...

Answer 10

A replacement for your Shelby 5138 is the Fulton Fas-Lok Coupler, 2" Ball, 3" Channel - 3,500 lbs #F223000301. This is a great quality coupler that is cost effective as you referenced. I've attached a review video of this product to…

view full answer...

Replacement Bolt-On Fulton Trailer Jack

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching