Is Bolt-Through and Weld-On the Same for a Fulton Swivel Marine Jack

Question

Question:

is a bolt-thru the same as weld-on jack... I need a both thru as it is attached with one bolt on trailer.

asked by: Vince S

0

Expert Reply:

In regards to the Fulton Bolt-Thru Swivel Marine Jack, part # FXP10W0301, bolt-through refers to how the jack attaches to the mounting bracket and weld-on refers to how the mounting bracket attaches to the frame. If the mounting bracket looks like the Jack Mounting Bracket for Fulton Marine Jack part # P9012-00 you will be good to go.

expert reply by: Conner L

0

Answer 1

Thank you for the photo it was helpful in determining what you need. The replacement would be the Fulton Bolt-Thru Swivel Marine Jack #FXP10W0301 which has a bolt-through mount, 1,200 lb lift capacity and has bracket heights of 12-3/4" retracted…

view full answer...

Answer 2

I have a replacement jack option for you, but after reaching out to my contact at Fulton the plate you showed in your picture is not offered as a replacement part. Your only option at this point is to go ahead and replace your jack with the Fulton…

view full answer...

Answer 3

It looks like you have a variation of the Fulton Marine Jack #FXP100W0301. For that the replacement bevel gear kit is part #F0933302S00 and work with Fulton marine and recreational jacks up to 800 lb to 1,200lb capacities. As long as your jack falls…

view full answer...

Answer 4

The correct replacement for the Fulton Magnum Series Trailer Jack on your trailer is the Fulton Bolt-Thru Swivel Marine Jack part #FXP10W0301 if you have a bolt-thru mounting bracket or part #FTJ120W0301 if you have a snap-ring mounting bracket. I…

view full answer...

Answer 5

We don't have the dimensions of the weld-on mount for your Shelby jack, but it looks similar to the Jack Mounting Bracket for Fulton Marine Jack - Weld-On #P9012-00. That mounting bracket uses a 1/2" bolt with pin holes measuring 3"…

view full answer...

Answer 6

I tried searching for the part number you listed but could not find anything with Fulton or online. However, if the mounting bracket on your trailer looks like the part #P9012-00 the Fulton Jack part #FXP10W0301 is going to fit and work well.

view full answer...

Answer 7

If the trailer is heavy, or the ground is uneven, it will be hard to move regardless of which jack you use but if the bearings are wearing out in the old one then a new one would surely take some strain off the user when moving. I recommend a dual…

view full answer...

Answer 8

Hey Dianne! The Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches item #ERT00108 weighs 35-1/2 lbs. What vehicle are you planning on using these on?

view full answer...

Answer 9

A boat trailer jack that uses a snap ring works differently than one that is a bolt-on, like yours, because the mounting bracket for a bolt-on jack and snap-ring jack will be different. Because you have a Fulton 1,200 lb bolt-on jack, I assume your…

view full answer...

Answer 10

Jason, from what it looks like the Fulton Boat Trailer Jack w/ Wheel #FXP10 should work great in the original location. This jack has a 1.2K capacity, a mounting bracket that measures 5 1/2" x 4 1/2", and will fit 3" x 5" trailer…

view full answer...

Is Bolt-Through and Weld-On the Same for a Fulton Swivel Marine Jack

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching