Diagram to Use When Installing Hopkins 7-Way HM48480

Question

Question:

I bought connector part #48480 but it doesnt have color code but gd for ground, LT for left turn etc but I need color code because my left means right and vice versa what do I do

asked by: Vladimir R

0

Expert Reply:

I attached a diagram that shows how a 7-way gets wired up by function. If you don't know the function of the wires of your truck you will have to use a circuit tester like part # PTW2993 to test each wire so that you can determine what it is and wire the 7-way according to the diagram.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Hey Kevin, it sounds like you are looking for the Hopkins part #HM45MV that you referenced. This will replace your current 7-way with a 7-way that has a 4-way built into the side of it.

view full answer...

Answer 2

There are several items you might want to try using for removal of corrosion in your 7-way trailer connector, like part #HM48480. White Vinegar A wedge shaped, slip on pencil eraser or art gum eraser Pipe cleaners PB Blaster If the corrosion is…

view full answer...

Answer 3

The Optronics 7-Way Connector - Trailer End #A7WCB will handle 8-gauge wires on the positive and negative connectors. If you want the same gauge wire on the vehicle side, I recommend the Hopkins Endurance 7-Way Trailer Connector Socket - Vehicle End…

view full answer...

Answer 4

Since your 2020 Ford Ranger SXT came with a factory installed 7-way trailer connector, you should have a brake controller connector under the dash. That being said, the connector that would most likely fit #3034-P, has not been confirmed as a fit for…

view full answer...

Answer 5

You can use the Curt friction style sway control, #17200 on the left or right side. You will need to loosen the handle and the other bolt below it, pull the inside arm out, flip it over, then reinsert it. You will then need to unscrew the handle on…

view full answer...

Answer 6

Yes, there is an adapter Steve. You'll want the Hopkins Endurance Multi-Tow Trailer Connector Adapter item #HM47570. This adapter will simply plug into your Sprinter's 7-way connector and provide you with a 4-flat to control your boat…

view full answer...

Answer 7

For your companion hitch the replacement pivot arms are now only available with the base which for your model 3000 is #BWRVB3500. I'm not sure what u-bolts you are referring to, so I assume it is the chains and that is part #BW1900-2-1600. If you…

view full answer...

Diagram to Use When Installing Hopkins 7-Way HM48480

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching