Search: boat trailer wiring harness   >  

The biggest difference between the servo styles that you'll notice is between free backing plates and the others. The free-backing plates will allow your trailer to back up without having the brakes lock up. With surge brakes typically when you…

I have a solution for you, but we do not have any hubs that use inner bearing #L44649 and outer bearing LM11749. This is an old bearing combination no longer used so replacement hubs aren't around anymore. It is for that reason that the best…

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

The best way to handle the grounds for lights on an aluminum trailer is to mount a junction box like #38656. You can then run ground jumpers from all lights back to the junction box and also connect the 4-pole such as #W787268. The box provide both a…

You can definitely add brakes to an axle without purchasing another one. The easiest thing is if your axle already has a brake mounting flange installed on it. If your axle doesn't then you can have one welded on, but we typically recommend…

All of the hubs that we carry with a 4 on 4 bolt pattern that also use inner bearing #L44643 also use that same bearing for the outer bearing. On your spindle it would not be the correct size. If the inner bearing is actually 1.0681 then it is…

This Submersible LED Trailer Light Kit with 25 foot Wiring Harness, part #TLL9RK, uses all stainless steel mounting hardware. The mounting hardware of this trailer light kit should work well in the saltwater conditions that you use your boat in.

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

The Hollywood Racks Sport Rider bike carrier #HR1450Z is designed specifically for use with cargo carrier #HR1485. While it is possible, even likely, that another carrier would fit at the back of the bike carrier I cannot recommend it because doing…

For your application I recommend checking out the Hollywood Racks Sport Rider SE2 #HR1450Z because it's easy to use and install compared to other racks at this price point plus it's large enough to hold your longer bikes. This is designed for…

Yes, if sounds like you're looking for the Trailer Axle with Idler Hubs #e72GR or Trailer Axle w/ Electric Brakes #e95SR for your application. These both match the hub-face and spring-center measurements you referenced, they have the 4"…

To upgrade to a larger tire you will have to upgrade to a larger wheel as well, and with that in mind you will want to make sure that the bolt pattern of your new wheel and tires match the existing bolt pattern on your current trailer. I have…