How to Pack Grease On Trailer Hub with EZ Lube Spindle
Published 06/23/2016
Products Featured in This Question
Question:
When repacking bearings on ez lube spindles is it necessary to fill the hub with grease when putting back together?
asked by: Mark
Helpful Expert Reply:
When you are assembling the hub components you want to make sure you fill every space of the bearings with grease like part # L11465. To make this easier you can use a bearing packer like part # L70025. If you do not have one, you can use a grease gun like part # L30200. After you have packed the bearings you will want to apply a thin layer of grease to the spindle before installing the remaining parts.
Then, insert your bearings and grease seal in the hub and mount your hub on your spindle. You should slowly pump grease into the spindle. As you pump grease into the spindle, you can rotate the hub so it allows the grease to be applied evenly.
You will want to continue to pump grease till you see the outer bearing move or you see grease coming out through the outer bearing. You want to be careful not to blow out the grease seal. You can then install the remaining parts.
I have attached a helpful article that explains how to replace and install bearings, races, and seals.
Product Page this Question was Asked From
Kodiak Ceramic Brake Pads - 3,500 lbs to 6,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- 3500 lbs
- 6000 lbs
- Brake Pads
- Kodiak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: trailer brakes
- Search Results: center caps
- Search Results: ac~490tt
- Search Results: ac 490tt
- Shop: Easy Grease Trailer Hub and Drum Assembly for 5.2K - 7K Axles - 12" - 8 on 6.5 - Pre-Greased
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Video: How to Install the Draw-Tite Max-Frame Trailer Hitch Receiver on a 2018 Land Rover Velar
- Video: Set up: Draw-Tite Max-Frame Trailer Hitch Receiver on a 2020 Land Rover Velar
- Shop: Trailer Wheel Center Cap Plug - Black
- Search Results: bk1~150
- Search Results: trailer wheel bearings
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-3/4 - Pre-Greased
- Shop: Complete Bearing Kit with L44649 Inner/Outer Bearings and 10-9 Grease Seal Fits 1.063" Spindles
- Shop: Bearing Kit for 1" BT8 Spindle, L44643 Inner/Outer Bearings, 34823 Seal
- Q&A: How to Determine Correct Idler Hub Assembly for Trailer With 3,500 lb Axles
- Q&A: What Size Bearings are Kits Available For?
- Q&A: Can Bearings for a 1-1/16 Inch Spindle Replace Bearings for a 1 Inch Spindle Using Same Hub
- Q&A: How to Find Replacement Bearings and Grease Seal for 1990's Shoreline Boat Trailer
- Q&A: Replacement Bearing Kit For 1" BT8 Trailer Spindle
- Q&A: Do E-Z Lube Axles Need Bearings to be Packed by Hand
- Q&A: What is Normal Temperature Rating for Trailer Hubs