How Does Winch Strap # DL24239 Attach to Winch Drum
Updated 06/04/2016 | Published 06/03/2016
Question:
How is the DL24239 attached to a Fulton FT6000301 winch drum?
asked by: David P
0
Expert Reply:
If you check out the review video I attached for the # DL24239 you will see exactly how it installs on a winch.
Basically you run the bolt through the hole on the drum of the winch, through the strap loop, and then through the other side of the drum where you use the nut to secure it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hand Winch Strap with Safety Hook, 2" Wide x 15' Long - 4,000 lbs.
- Accessories and Parts
- Trailer Winch
- Cables and Straps
- 2 Inch Wide
- 2600 lbs
- Straps
- 15 Feet Long
- Dutton-Lainson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Federal Requirements for Clearance Light Placement on a Trailer
- Q&A: Is It Possible to Upgrade my Pontoon Trailer Tires and Wheels From 10-Inch 5 on 4-1/2 to 14-Inch
- Q&A: Recommended Replacement Winch Strap for a 2" Hand Winch
- Q&A: Replacement For Dutton-Lainson Winch DL2000
- Q&A: Comparing The Dutton-Lainson Hand Winch # DL14627 And # DL14725
- Q&A: Choosing The Correct Replacement Boat Trailer Winch Strap For A 24' Cobalt Boat
- Q&A: Is The Mounting Hardware For The Optronics LED Clearance Light # MCL95AB Rated For Salt Water
- Article: Trailer Wiring Diagrams
- Article: How to Wire an Electric Winch
- Article: Trailer Tire Sizing
- Article: Brake Controller Installation: Starting from Scratch
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Converting Your RV Water Heater to Tankless
- Article: Is It Illegal to Leave My Hitch on My Truck?