How to Install a Brake Controller in a 2008 GMC Envoy
Published 04/09/2015
Question:
Can you send me a wiring diagram for the DrawTitie Activator IV as far as installing it on a 2008 GMC Envoy? I had it on a Trail Blazer and need to switch it to my new car but my mechanic needs to know how to connect the electric.
asked by: Gloria M
Expert Reply:
To install a brake controller in your 2008 GMC Envoy there are 4 blunt cut wires under the dash that the controller will wire to using butt connectors.
Have your mechanic check out the link I attached that details everything needed to install a brake controller in your vehicle. I also attached an install video.
Product Page this Question was Asked From
Draw-Tite Activator IV Trailer Brake Controller - Up to 4 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Plug-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LED Display
- Single Trailer Only
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Trailer Wiring Harness for 2024 Hyundai Santa Fe
- Q&A: Replacement Brake Assemblies for a Lippert 4,400 lbs Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: How Do the Heavy Duty Ramp Springs Install on a Trailer and Ramp
- Q&A: Availability of Metric ATV Hub Assembly With 4/110 Millimeter Lug Pattern
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Replacement Trailer Clearance Lights PM-108-15 SAE-AP2-79
- Article: Troubleshooting Brake Controller Installations
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)