2018 Toyota C-HR Vehicle Lights

Hello again Michelle. The Saris Glide EX Bike Rack #SA774 will indeed fit a 2023 Hyundai Tucson with a class 3 hitch. The tilt feature will allow the hitch to open and close normally. Saris bike racks are definitely good quality. They are all made…

We do offer teardrop style clearance lights in red, the Pacer Performance Hi-Five Truck Cab Light Kit part #PP20-215 which are sold as a set of five. These lights by law must be installed so that they face the rear of your vehicle. They come with…

The Vision X 9007 Halogen Headlight Bulbs with Relay Harness #VX-H9007-R uses a combination of 16 and 18 gauge wire. It may seem thin but with short distances like with this harness 16 and 18 gauge wires can actually handle a surprising amount of…

I recommend picking up the Durabilt Safety Chain Connectors for…

You are correct the hook ups are for the lights on the Blazer LED Cube Light Kit #BL28VR. The different ratings are for each of the circuits. The lights that come with the kit will fit onto the smaller connections allowing you to connect more…

Congrats on the new truck! To add an in bed 7-way connector to your 2023 Ram 3500, I recommend the Mighty Cord 5th Wheel/Gooseneck Wiring Harness w/ 7-Pole Connector item #A10-7007. This harness puts a 7-way connector in the bed of your truck and…

According to my research we do have a few options that will work as a replacement for your E333645 LED light: Cool White - 180 Lumens/5,500 Kelvin #DI56VR - 165 Lumens/5,500 Kelvin #DI86VR Warm White - 180 Lumens/3,500 Kelvin #DI29VR - 165…

You can either look for the factory plug behind the bumper on the driver side or you can call your local dealer and have them look it up with your VIN number. Assuming you have the factory tow package you can use the T-One Vehicle Wiring Harness…

Because the face of the magnet rides against the armature (inside) surface of the brake drum, any grooves that had previously been worn into the armature surface will cause the magnet to wear unevenly. For optimal braking performance, you want…

Thanks for the axle information, Mike! Here are the correct parts according to my contact at Curt: - Bearing #02475 and Race #02420 - Bearing #25580 and Race #25520 - Grease Seals #RG06-070

If the lift motor will no longer operate with the controller but does when you apply direct 12 volt power then that tells me there is an issues with the control board. The only way to replace the control board on the Fan-Tastic Vent Roof Vent part…

Hello Michelle. To answer your first question, the Kuat Transfer 4 #KU77FR should not touch the ground when tilted on a 2023 Hyundai Tucson with the Curt Class 3 Hitch #C94WR, but it will be very close. We tested this bike rack on a 2018 Subaru…