Easy way to tell which flip kit you need is by measuring the diameter of your axles. If they measure 2-3/8 inches you do need the kit part #K71-384-00 that you referenced. If you instead have 3 inch diameter axles you'd want the part #K71-385-00.…
Thanks for the information and photo, Kenneth! It looks like your trailer is equipped with 3,500 lb axles so to replace your bearings and seals you need the kit #BK2-100, but it also looks like you have an older disc brake kit with a design that…
Tongue weight for a convention tow travel trailer is 10% to 15% of total trailer weight. If you were to fully load your trailer to 100% of it's capacity (4300 pounds) then your tongue weight would be 430 to 645 pounds. That leaves 3655 to 3870…
Hey Bekzod, So while we don't have a way of knowing the exact leaf springs for your Arctic Wolf 5th wheel trailer, I can help you determine the correct replacements. You do have to take a measurement, though it's pretty easy, as all you need…
Hi Todd, To go with trailer leaf springs that are slightly stiffer than the 4,400 lb rating of your axle you can go with 4,500 lb springs or 5,000 lb springs. The right one is going to depend on the length of your current springs though, as…
The Equal-i-zer brand is a great choice because of its extremely high-quality sway control combined with how easy it is to set up relative to other weight distribution hitches, and we can point you in the right direction in regards to size. The right…
The ALKO 4,400 lb axles use the same bearing sizes as the standard 3,500 lb alxes. If you want USA made bearings, I recommend the Bearing Kit #TMK52VR. This kit comes with the Timken brand bearings which are all made here in the USA.
I attached an install video that will help you replace the Ventadome style roof vent on your RV. In the video it's the Ventline cover part #BVD0449-A01 but this is the exact same design as the #BVE0108-00 you have.
Good news, the Ventline Replacement White Dome #BVE0108-00 will fit your EZ-Lift Vent. I looked at the smoke replacement dome you looked at, and you are correct they look slightly different, it appears the smoke one has reinforced edges on the end.
I spoke with my contact at Ventline and she stated that if you have a newer EZ Lift Ventadome, the correct replacement lid will be part #BVE0108-03. This smoke color lid features a plastic hinge with four mounting points. You can compare the hinge…
The Dexter "8-256" is a hub assembly that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in a few different bolt patterns therefore you would need to confirm your bolt pattern using the attached help…
Hi Bill, The Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA92-00-0450 has a tongue weight range of 200lbs - 450lbs so you'd be right around the middle of the capacity when loaded, making this a great choice. This doesn't come with…
