Videos
for Kia Sedona Owners
Help Articles
for Kia Sedona Owners
Expert Answers
for Kia Sedona Owners
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...If you have a 4-way trailer connector like #118418 then I recommend using a wishbone harness to wire your trailer. The 20 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 30" Ground #A20WB is my recommendation for your wiring because it will…
view full answer...To remove a Yakima lock cylinder from one of their racks you need to have the lock core in the unlocked position and then insert a control key like part #Y8007835 into the core and once it's fully seated in the core you can pull it out.
view full answer...I looked up the towing capacity of your 2016 Kia Sedona and it looks to have a towing capacity of 3,500 lbs so a 2,700 lb camper would be no problem at all. For a hitch you then would want the Draw Tite part #75894 which is a confirmed fit. I…
view full answer...Trailer hitch/vehicle towing capacities are limited by the lowest rated component in the setup. The Draw Tite hitch part #76227 has a tongue weight capacity of 600 lbs which means it's over-built for your vehicle that has a 200 lb tongue weight…
view full answer...Without knowing what truck you have it's hard for me to know if you have the correct harness. I will say that the problems you are describing are unlike any problems we have ever seen from installing a brake controller. If removing the brake…
view full answer...I have a different option for you, but there is no such adapter for raising and lowering your Bulldog 12,000lb trailer jack with an electric impact. The only non-manual option offered is the Bulldog Powered-Drive Kit for Single-Speed Jacks w/…
view full answer...We do offer a replacement Spring Hinge for the Sears X-Cargo Sport-20 rooftop boxes, part #TH14933. The part #TH14936 you referenced is not an ideal fit for your Sears X-Cargo Sport-20 due to the stiffness of the spring.
view full answer...The replacement hinge that Thule recommends for the Sears X-Cargo cargo box is part #TH14933. The other similar hinge part you referenced, item #TH14936, will also fit but the tension of part #TH14933 is closer to that of the original part.
view full answer...The special trailer tire size 4.80-8 does have an overall diameter of right around 16-inches when the tire is mounted on the rim and inflated. The other popular trailer tire size that has about the same overall diameter is the 165/65-8 size, which is…
view full answer...Most Vehicles and hitches have their own specific hardware to insure proper fit and towing capacity. Our #C13149 hitch includes a hardware kit and installation guide. I attached a video on the installation for your convenience. The hardware specs can…
view full answer...You can have the height difference between the hitch height and base plate height 3 inches higher or lower. Check out the picture I attached to see that. Ideally you are as level as possible, but based on the height difference you have of 2 inches…
view full answer...