We offer one hitch for your 2011 Toyota Camry Non-Hybrid SE, part #36416 from Draw-Tite. This is a Class II hitch with a 1-1/4-inch receiver opening. No 2-inch hitches are offered for your 2011 Camry. This is because hitch makers base their hitch…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
Hey Richard, for your 2011 Toyota Camry LE V6 with the dual exhaust, I actually recommend the Draw-Tite Hitch #36416. This hitch was designed with the dual exhaust models in mind, and we have had many customers report back to us that it will fit the…
The correct replacement cradle for the Thule Passage bike rack #TH910XT is actually the Stay-Put cradle #853-7887. If you also need a strap it is #852-3006-001 and the anti-sway cage that fits is #853-7758.
We offer adapters so you can use the 2 inch bike rack with the 1 1/4 inch receiver hitch. The appropriate adapter for your hitch depends on what class it is. You can use part #HTAD if your hitch is a Class I or Class II and part #80303 will only fit…
You are experiencing a common dilemma. The use of any adapter does decrease the hitch tongue weight capacity by 50%. If your MKX Class II hitch offers a 350 lbs tongue weight capacity then with an adapter the bikes and rack combined cannot exceed 175…
I would discourage the use of an adapter for use of 2 inch accessories in 1-1/4 inch trailer hitch receivers. The reason is that the adapter places the carrier farther away from the rear of the vehicle and hitch, creating additional torque that 1-1/4…
Hello Richard. We do have an adapter, the Brophy Hitch Adapter #HT5R which may work very well for you. This will go in to the 1-1/4" receiver on your Camry and give you a 2" receiver with 5" of rise. It is very important to note that…
When picking out a fairing you want to go with a length that matches the width of the roof of the vehicle. Since your bars are 49 inches in width you would want to go with a 38 inch fairing #RRRF2 to allow a better match to your vehicle.
You are correct that both the Curt #C94WR and Draw-Tite #DT22MR you were looking at for your 2022 Hyundai Tuscon are very similar. Both hitches share the same 525lb tongue weight and 3,500lb trailer weight ratings, both share the same hidden…
I recommend the Curt Trailer Hitch Receiver #C12343 for your 2008 Toyota Camry hybrid. This receiver is going to be the easiest to install as it is custom fit and does not require any drilling to mount the receiver. The T-One Vehicle Wiring Harness…
When installing Curt trailer hitch #C11576 you will need to remove the tie down bracket from passenger side frame rail, trim a 4.25" x 2" portion from the heat shield and trim a 4.75" x 10.0" portion from the underbody panel. I…
