Videos
for Toyota Sequoia Owners
Help Articles
for Toyota Sequoia Owners
Expert Answers
for Toyota Sequoia Owners
The Yakima Replacement T-Bolt with Nut for Yakima Rack and Roll Trailers - Qty 4 #Y8880184 will fit in the channels of your HD bars, but for the most part, crossbar mounted accessories will come with (or have available) T-channel hardware that will…
view full answer...I am far from an expert on snowmobiles but one would have to think such a large truck with the correct tires and chains would be able to make it through up to 2' of snow assuming you have clearance on the vehicle. In regards to the type of tire…
view full answer...The Titan Chain Snow Tire Chains part #TC2828CAM do not fit a 265/65-17, however we do have tire chains that will work with your Tacoma with that size tire. I recommend Konig Standard Snow Tire Chains Size 265, part #TH01571265. They have dual sided…
view full answer...Since your 2008 Toyota Sequoia came with a factory tow package, you can plug in the wiring harness, #3040-P into the port on the vehicle. It is located under the dash to the left of and above the the emergency brake. You will remove the panel that is…
view full answer...On your 2018 Toyota Sequoia the factory brake controller plug is located underneath and to the left of the steering column, taped to another harness near the emergency brake pedal. There will be a 5-pin connector that mates with the one on harness…
view full answer...The correct install harness is the part #C51362 to install the Curt Spectrum part #C51170 in your 2003 Toyota Sequoia.
view full answer...The SumoSprings Helper Springs, #SSR-302-54, will operate with no issues under normal driving conditions. The springs are designed to begin to impact the truck's suspension when the suspension is under a load. The OEM suspension components, like…
view full answer...Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…
view full answer...I took a look at the installation manual for both the Firestone Coil-Rite #F4124 and AirLift 1000 Air Helper Springs #AL60812 that fit your 2003 Toyota Sequoia and the directions do differ a bit in terms of cutting the factory bump stop. The…
view full answer...Yes, the 921 bulb #VA0415-00 will work well for you. The 912 and 921 bulbs are interchangeable as they have the same T-5 wedge base. The 921 has a wattage of 16.8 and draws 1.4 amps. The 912 is 12 watts and draws 1 amp. So the 921 should burn…
view full answer...Yes, the SumoSprings Solo Custom Helper Springs #SSR-127-54 will work very well for your 2022 Ford F-250 Super Duty. The helper springs have progressive load control allowing them to compress by as much as 80 percent for support when you're…
view full answer...First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part #PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached. If the voltage…
view full answer...