2009 Cold Air Intake

The PR4 leaf spring which we sell as #e28SR is not interchangeable with the PR4B which we sell as part #e54SR. The springs are different lengths and capacities, with the #e54SR being 25-1/8 of an inch long for a 3500 lb axle and the #e28SR being…

Old springs tend to stretch out as they wear out so in your situation you would want to go with a slightly shorter spring like the 25-1/4 inch length which we have in a 4k capacity part #e57SR, 5k with part #e28SR, or 6k part #e78SR.

The Adarac Pro Series truck bed ladder rack part #A38ZR is a confirmed fit for your 2020 Jeep Gladiator, is black, has a 500 lb weight capacity, and is compatible with tonneau covers like the BAK X4 part #BAK88ZR that fits your 2020 Jeep Gladiator.…

The #168233 Double Lip Grease Seal has an outside diameter of 2.332 inches and an inside diameter of 1.688 inches. This seal is not compatible with a AF2527E seal with a O.D 2.312, because, even though the O.D. id very close, the inner diameter of…

Pulling the wheels and hubs off of your 5th wheel trailer is the best option when trying to identify what wheel bearings and seals are installed. On the back of the wheel bearings there usually is printed a part number like #L44643. With these…

I do have an option for you but Atwood was bought out and their replacement parts are no longer available, including the repair kit you would need. The best option is to replace that A-frame coupler with a new one that attaches to a 2 inch hitch…

The Blue Ox Patriot Portable Braking System - Proportional #BLU37TR does not have an internal battery so it will require you to install a 12v outlet #RM-9332 since your 2009 Jeep Wrangler requires you to disconnect the positive battery cable. This…

The issue you are having with the gooseneck hitch ball getting stuck in the trailer hitch after sitting is pretty common, especially with the factory pop-in hitch balls that have the latch in the top like the Curt Ball and Safety Chain Loop Kit…

The OEM location for the gooseneck ball hole in the bed of your 2020 Ford F-350 will be 45-1/2 inches forward from the rear edge of the truck bed. There would be a flat spot in the bed where the ball will install as well. I attached a picture that…

In regards to the Linxup GPS Tracking Device part #300-AT3, once you install the GPS device, you'll be ready to choose and set up the Linxup service plan that works for you. When you purchase a service plan, you can…

We do have a trailer hitch receiver that fits your 2024 Nissan Pathfinder, from Curt. The correct part number is the following: - Curt Trailer Hitch Receiver #C46DR

Polyurea is in the wheel bearing grease and is compatible with marine bearing grease but not the Red grease. Red grease is compatible with marine grease but not standard. I attached a help article that has a chart with all of the grease…