Review of RV Designer White Weatherproof TV Jack - RD98FR Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The RhinoEXTREME RV Sewer Hose w Swivel Fittings, 4-in-1 Adapter, and Caps - Black - 15' Long #CAM39861 is compressed to a length of approximately 6-1/2 feet. I went out to the warehouse to measure it for you. If you are wondering if it will fit…

Since sewage connectors do need a proper seal (typically by using solvent #A05-0303) I do recommend changing out some of your sewage pipes as they are looking a bit rough. It does look like you have a 3" round pipe from your photo so if you were…

The RhinoEXTREME RV Sewer Hoses w Swivel Fittings #CAM39867 referenced in your question include two 10 foot long hoses, along with swivel bayonet, lug, elbow fittings, a 4-in-1 adapter and storage caps. These hoses will compress to allow for easy…

You were real close with your guess! The 15 foot RhinoEXTREME RV Sewer Hose #CAM39861 has a compressed length of 6-1/2 feet, or 78 inches. I have added a link below to a video review for you as well of the RhinoEXTREME RV Sewer Hose #CAM39861.

The best sewer hose system to store inside a rear bumper is the RhinoEXTREME RV Sewer Hoses w Swivel Fittings part #CAM39867. This system comes with caps to keep the odor contained so when you are done you can compress the hose, cap it off, and slide…

Dumping tanks is probably an RV owner’s least favorite task but truth is it is really not all that bad. You will need the proper connections to your tank, hose, and the waste station connections. There are multiple options of each but I suggest the…

Yes, the RhinoEXTREME sewer hoses like the part #CAM39867 will easily fit in the bumper of an RV like where most people store them. These have the same dimensions as standard hoses.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…