1948 Jeep CJ-2A Replacement Top

Hey Carole, thanks for reaching out! The Swagman Swivel Hitch Extender #S86SR has arms that are about 29-1/2" long. Swagman actually has a dimensional photo that gives more dimensions that you'll ever want that I'm attaching for you to…

Good question, Chuck! You will not need the Brake Relay #RM-88400 when installing the Roadmaster 4 Diode Wiring Harness #RM-15267 on your 2018 Jeep Wrangler JL Unlimited. This is because the stop light switch circuit on your Jeep JL will go dead…

Hello Andrew, Well that sounds like quite the fun trip, what state or states will you be traveling through? You're asking a really important question, especially since you're planning a cross-country trip with about 250 pounds of bikes and…

Hey Neal, we have confirmed with Curt in the past that the front hitch part #C73ZV is confirmed to fit your 2022 Ram 2500 Power Wagon. What are you planning on putting in the front hitch?

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

Hello Christopher, We do not have the bow system for your 1993 Isuzu Amigo, and that is part of the roof frame. That is required, as well as the factory hardware for a replacement soft top, so if you have that you can use the Pavement Ends Replay…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I have another option for you, but the Timbren Heavy-Duty Axle-Less Trailer Suspension - Straight Spindle - Regular Tires - 3,500 lbs #TASR35HDS04 you were looking at actually uses 5200lb hub and drum assemblies and is not available with the 5 on…

Although the #TASR35HDS04 Timbren Axle-Less suspension you'd looked at has a 3500 lb capacity but is compatible with hubs that would have a 5200-7000 lb capacity, depending on which bearing set is used. We don't offer an idler hub compatible…

Yes the Roadmaster diode tow bar wiring kit part #RM-154 is a fit for your 2018 Jeep Wrangler JK Freedom Edition. Roadmaster does not recommend the use of the brake light relay part #RM-88400 with this either on your vehicle.

Most likely you will not need a brake light relay for your 2015 Jeep Wrangler Unlimited. I recommend wiring the Wrangler first and checking to see if you need a brake light relay before installing it. You will want to connect the Jeep's wiring to…

Whenever you are testing for the cold side of the brake switch you'll want to use a volt meter like #PT89ZR rather than a standard test light, which I assume you are since you gave me the numbers of the read outs. The cold side of the brake…