Car Seat Covers Specs:
Features:
...it from shifting Machine washable - hang to dry Made in the USA Specs: Application: rear bench seats with headrests Size: medium 1 (see table for sizing information) Color: Taupe Dimensions: 52" wi...
More Information >Car Seat Covers Specs:
Features:
...Made in the USA Specs: Application: high-back rear bench seats with headrests Size: small high back (see table for sizing) Color: Taupe Dimensions: 56" wide x 19-1/2" deep x 22-...
More Information >Car Seat Covers Specs:
Features:
...table for sizing) Color: taupe Dimensions: 56" wide x 19-1/2" deep x 22-1/2" tall 90-Day limited warranty Measure the seatback height, seat depth and seat width of y...
More Information >Videos
for Car Seat Covers
Help Articles
for Car Seat Covers
Expert Answers
for Car Seat Covers
It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…
view full answer...The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.
view full answer...I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine,…
view full answer...Generally speaking, the lube plate will need to cover the skid plate on the 5th wheel hitch. There are some pin boxes out there that will recommend a specific lube plate but most of the times this classification will be from the 5th wheel hitch…
view full answer...For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where…
view full answer...You do not want to use a holding tank heater like ThermaHeat #277-000164 on a battery but we do offer battery heaters specifically intended to protect one from extreme cold. You can see all such items on the page I linked for you.…
view full answer...To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…
view full answer...From the looks of the photo you sent it does not look like you have an OEM suspension system on your boat trailer. I recommend securing the suspension rail to the trailer frame in a more secure manner like drilling and using bolts so that it does…
view full answer...We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…
view full answer...The best way to determine the weight capacity of your leaf springs would be to check the weight rating of the axle on your trailer. The trailer will have a plate or sticker on it that will list the VIN number. The weight rating of the axle should…
view full answer...As it seems you already know, when installing a trailer brake controller on your 2007 GMC Yukon you will need to locate the two wires under the hood that need to be connected to fully activate the…
view full answer...