Search: lp51cb   >  

Hi Michael, While we don't have any way of knowing what winch stand goes on any specific trailer, it is possible we have an option for a winch stand for your Karavan trailer. The only option we have for a stand is the CE Smith Winch Stand…

Yes, you will need to replace the spring with something like Item #e74SR. It is best to replace all springs at the same time so that you have even support and maintenance for the trailer. We do not carry 2 inch never fail bushings. I contacted…

To bypass the factory integrated brake controller (ITBC) on your 2012 GMC Sierra 3500 you will need to access the blunt cut wires under your driver's side dash. Once you have these you can connect your aftermarket brake controller. I recommend…

Yes, the Curt hitch part #C77ZV is a fit for the 2023 Toyota Crown Hybrid. I attached a link to the install instructions as well as a link to an installer finder in case you wanted to find someone near you to install the hitch.

The CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies part #CE10196G-4 can be used on a 4" frame with the CE Smith U-Bolt part #CE15254A.

The part number you gave is no longer a valid number for Bulldog jacks. It sounds like you are looking for the Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 15" Lift - 5,000 lbs #BD190754. This has a 5,000 lb lift capacity and an…

The Lippert High-Speed Power Stabilizer Jack #LC298707 would not be able to mount to your frame since you only have 68-1/4" from outside to outside edge and this stabilizer requires a 68-11/16" spacing. Instead I recommend installing the…

You made a great choice in the Lippert Components Power Stabilizer Trailer Jack. For starters, all of the jacks measure to be 70-1/2" long with a 3,500 lb weight capacity and have a 30" lift. The difference between them is in regards to…

The Lippert High-Speed Power Stabilizer Jack #LC298707 is a stabilizing jack which means it does not lift your trailer at all. The jacks are only meant to come down and press against the ground to stabilize the trailer so you don't feel the…

Yes, the 30" lift Lippert High-Speed Power Stabilizer Jack, #LC298707 can be installed on the front and rear of a travel trailer. Please note that this jack is designed to stabilize your trailer an not to support the full GVWR. Do not use these…

Thanks for the photo. It's hard to tell the exact outer diameter of the cap but I believe we do have options for you which I have attached below. Trailer Wheel Center Cap Plug - Chrome part #AM90082 (2-1/16" Outer Diameter) Trailer Wheel…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…