Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Technically there is no limit to how long a propane hose can be. However, the general consensus is that it should be no longer than 20' like the #1000914-240-MBS. Any longer than 20' and you may experience problems with pressure and flow.
view full answer...Based on the pictures you sent in you are in need of the MB Sturgis Propane Hose - 3/8" Female Flare x 3/8" Female Flare Swivel - 15' Item #MBS57FR. If you need just a 12' hose then you'll want the MB Sturgis Propane Hose -…
view full answer...I took the Ultra Faucets RV Shower Valve w/ Vacuum Breaker #277-000024 apart and found that the cartridge only fits one way and they make the valves so that you wouldn't be able to disassemble and rotate the connection to the bottom. Since…
view full answer...MPT is a male connection with NPT threads (national pipe threads). They basically just drop the "National" portion of the name on these parts and replace them with the male or female designation. The MB Sturgis Propane Hose Assembly -…
view full answer...Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…
view full answer...The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…
view full answer...After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…
view full answer...Hey James, you can go with a 4k axle leaf spring like the part #e22YR in place of what you have now while it has a slightly higher weight capacity it's not enough that it would create a harsh ride quality. This is a 26 inch long spring though so…
view full answer...No, I am sorry Don. The Gen-Y Torsion Weight Distribution Shank - 2-1/2" Hitches item #GY92NR does not fit the B&W Continuum Weight Distribution System item #BW78FR. The shank on the Continuum is quite a bit wider than the standard size on a…
view full answer...Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…
view full answer...Filters
13 results
Vehicle Fit
Fit 2017 Chevrolet Cruze