Result: roadmaster base plates

In order to use the Roadmaster Direct Connect Base Plates #280-5 with your Demco Excali-Bar #DM9511013 you will need to use the Demco Tow bar Adapter for Roadmaster Base Plates #DM9523032 . This adapter works as an adapter to the Roadmaster MS…

For your 2023 Ford Ranger XLT we have the Blue Ox base plate kit part #BLU77XR as a confirmed fit. The Blue Ox base plates are really easy to connect and disconnect from tow bars so they are a great choice. In addition to the base plates, you will…

You are in luck! We actually have a video on that base plate kit being installed on a 2023 Ford Ranger. The Blue Ox Base Plate Kit #BLU77XR that we carry is the BX2689 that you have. I have included the installation video for you here to check out.

The blue wire coming from the brake controller to the trailer brakes is the brake power output wire used to tell the trailer to apply the brakes once given the response from the brake controller. Therefore, you should not have a constant charge to…

You'll need to install a Roadmaster Brake Light Relay, part #RM-88400. The purpose of a brake light relay kit is to prevent your towed car's brake signal from overriding the turn signal that comes from your RV. When your towed vehicle is…

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…

So that you could have both a 4-way and a 7-way connector at the rear of your 2015 Nissan Pathfinder you would want the part #118273 which is a kit that will install a 7-way, but instead of using the 7-way that comes with it you would install the…

If you have a 2014 Ford Edge with a 4 cylinder engine, it will need to be towed on a tow dolly like the Roadmaster Tow Dolly with Electric Brakes - 4,250 lbs #RM-2050-1. This system does require the Pollak Black Plastic, 7-Pole, RV-Style Trailer…

To flat tow your Jeep Wrangler JK behind your motorhome, you will need a base plate kit, tow bar, safety cables, tail light wiring harness, and a supplemental braking system. Depending on the year of your Wrangler, you may also need a Brake-Lite…

For your Roadmaster Sterling Tow Bar #RM-576 the replacement stinger part #910019-40 is the correct replacement. The nut is included so if you need a horizontal bolt too you'd also need the part #RM350191-00.

Yes we have confirmed with Roadmaster that the shank #910019-40 does fit the Roadmaster Sterling models that had a 6k capacity so this would work.

The replacement shank you need for your Roadmaster Sterling is the part #910019-40 that you referenced.