Result: lock pin

I couldn't be 100% positive about which wheel studs you'd need without seeing the trailer and being able to measure. I just don't have enough information. This bein said, by virtue of the trailer having a 5 on 4-1/2 inch wheel bolt…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

In regards to the Curt Trailer Hitch Receiver part #C15704 which is a fit for a 2003 Dodge Ram 3500, the distance from the top of the flange to the top of the hitch cross tube is 6.65" exactly.

The Class V hitch we have for your 2004 Dodge Ram 2500 with the best ground clearance is the Curt hitch part #C15809. It doesn't tuck right under the rear bumper like what you can see in the attached picture but it does sit the highest.

The Curt Trailer Hitch Receiver Class V #C15704 referenced in your question is confirmed to fit the 2006 Dodge Ram Pickup 2500-3500 Series without a factory trailer hitch. I recommend making sure that the factory hitch on your Ram can be removed, as…

The instructions call for the complete removal and relocation of a 20" spare tire so if your spare tire is a 35" then I have my doubts about it fitting. The only way a spare tire will fit with the Draw-Tite Hitch #DT45509 is if it's no…

If your 2015 Ram is a 2500 or 3500 then the Draw-Tite Trailer Hitch Receiver - Custom Fit - Class V - 2-1/2" #DT45509 you were looking at is going to be a compatible fit.

I would love to help but I can't really tell you if you need the B&W Tow & Stow 2-Ball Mount with 5" Drop part #BWTS20037B (part #BWTS20037C) or 7" Drop part #BWTS20040B (part #BWTS20040C) as it varies by application so you will…

The B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25211 is designed in a way that it will fit with or without a factory receiver. The multiple mounting points on the side plates will decide where the receiver sits. When you remove your factory…

We have two Class V hitches that are designed to fit your 2014 Ram 2500 without a factory hitch installed. The hitch I recommend is the Draw-Tite Trailer Hitch, part #DT45518. This has a 2-1/2 inch receiver opening. To see how far below the bumper…

The factory trailer hitches on the 2006 Dodge Ram 2500s are welded on. You can add a Class V Curt hitch, #C15409 for a 2 inch receiver or #C15809 for a 2-1/2 inch receiver, and either will install beneath the factory hitch. I have linked videos…