Search: 76194 > Trailer Hitch >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Will thanks for the question! The Curt Hitch item #C13409 is compatible with the automatic tailgate switch on your 2025 Subaru Forester. You'll lose some of the sensors range around the 2" receiver but you're not going to want to be…
view full answer...You are correct that the Subaru OEM hitch will sit higher than the Curt #C13409. The OEM hitch will be much more flush with the bumper, while the Curt hitch will sit about 2"-2.5" lower, leaving space between the bumper and the receiver. We…
view full answer...Hello Geoffrey. For your 2020 Toyota Highlander Limited AWD I recommend the etrailer Class 3 Hitch #e75ZR. This hitch will be compatible with your T165/90D18 temporary tire. Anything larger than an 18" wheel would not fit, but you will be able…
view full answer...For some reason Toyota isn't very forthcoming with how to figure out if you have the tow package or not. From my understanding all of the V6 models of the 2019 Toyota Highlander have the tow package but it isn't specified as to what else…
view full answer...To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…
view full answer...The expert reply you were looking at is correct. The only way to confirm if your 2019 Acura RDX has the plus 12 volt power provision is by removing the interior trim and seeing if the factory connector has one or two red wires. I can completely…
view full answer...With the Tekonsha Prodigy P3 Trailer Brake Controller #90195 showing Output Shorted, No Brakes it is telling you there is a short in the wiring from the brake output wire to a ground or other wire. Since you do not have a trailer connected you will…
view full answer...Yes, it does! The Curt Hitch item #C86FV has been confirmed to fit all models of the 2024 Mitsubishi Outlander including the PHEV. This is a class III hitch with a 2" receiver. It has a 200 lbs tongue weight capacity so it will work great with…
view full answer...I wasn't able to find specific information for your trailer with the part numbers you provided, but I do have some options for you. There are two things you need to look at when replacing your wheel cylinders. You need to know the size of your…
view full answer...Hey Jim, you could also use the 215/75-14 if they have those in stock. We do have the exact size you're looking for in stock with #AM10235 but you wouldn't be able to pick it up same day. Out of curiosity, what kind of trailer do you have? If…
view full answer...The recommended torque spec for 1/2 inch coned lug nuts, like #12CLN is 90-100 ft-lbs when used in conjunction with a 15 inch aluminum wheel, such as #AM22653. If you don't already have one, I recommend using a torque wrench #ALL944001 to…
view full answer...A replacement tang-style spindle washer like part #5-101 is intended to be installed behind the castle nut and have its prongs bent down so that they prevent the castle nut from rotating on an E-Z Lube type spindle. The castle nut holds the washer in…
view full answer...Filters
- 1 results
Vehicle Fit