Search: 40005   >  

I was not able to reference the grease seal "5013/29772". We may still have a replacement for you but I would need you to measure either the inner diameter (I.D.) and outer diameter (O.D.) of the grease seal or the part of the spindle where…

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

I took a look at the Bargman Door Latch 10-30-051 that you referenced and it is indeed oversized. The best option we have to replace this would be the Global Link RV Entry Door Locking Latch Kit part #295-000019 which can install in an opening up to…

The Solera 69" Standard Flat Awning Support Arm #LC281154 is the correct replacement for your 2020 Grand Design Transcend Xplor Travel Trailer.

I have a solution for you but the Tekonsha Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers item #3016 does not fit your 2013 Chevy Tahoe. It is for 2014 GM trucks and suv's. The correct wiring harness you will need to connect your…

Hey Jeff, appreciate all the details you provided that was super helpful and we do have the MORryde cushioned pin box that is designed to replace a Lippert Rhino pin box. For the 17,695 lb GVWR you mentioned on the 2024 Brinkley Model Z 3610, what…

I can help you with towing items for your 2018 Tucson that will work for both your utility trailer and your potential teardrop camper trailer. I recommend the Draw-Tite 2-inch hitch #75836 for its straightforward bolt-on installation, which is shown…

Based on what we could find, the AL-KO 8490 is a 3,500 lb axle, and your info stating the 5 on 4-1/2" bolt pattern and 10" x 2-1/4" drum size supports that as well. I do recommend verifying what you need by taking apart your current…

Yes, for this you are going to want to take a look at a powered drive conversion kit like the Bulldog Powered-Drive Kit for Single-Speed Jacks part #BD1824200100. This kit is designed specifically for Bulldog trailer jacks but can most likely be used…

Sounds like your trailer axles are a bit too short if the inner sidewall is rubbing on the frame of the trailer. Did you recently change to a wider tire? That could be the cause too. Your equalizer being angled shouldn't cause the issue you…

Sounds like you went with axles that are too short for your trailer. Your best option is to replace the axles with ones that are longer so that the tires stop rubbing. You might be able to go with a skinnier tire setup but I would need to know what…

Dometic bought Atwood some time ago and has slowly been phasing all of the Atwood models out so we do have a replacement for you but not the exact same model. The Dometic RV Water Heater #DMC74FR would be the closest replacement 6 gallon water heater…