Search: 3200 > 5th Wheel Hitch >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Jeff! If your current lines are in good shape, you can just add a T-fitting and run lines to the second axle, no need to replace the main line. Your actuator and line size are already designed to handle multiple calipers on a tandem setup like…
view full answer...Hey Seth, the AL KO 4,400 lb trailer axle is pretty unique so I don't have a way to guarantee we have replacement bearings for it as we've heard all sorts of combinations over the years. I would need you to pull a hub and then get the bearing…
view full answer...Using the cut off wiring harness you have for the P3 part #90195 you will wire it to the brake controller wiring of your 2023 Ford Ranger which is sticking out of the large wire harness that goes through the driver's side firewall, left of the…
view full answer...The torque specs for 9/16" diameter u-bolts like the U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles part #APUBR-9 will be a range, from 65 ft. lbs. to 95 ft. lbs. If the tie-plates start to bend inside this range that would be…
view full answer...The 2021 Chevrolet Express is a difficult vehicle as it does not have a cold side on the brake switch for installing the Prodigy P2 Brake Controller #90885. Instead you will need a Fuse Circuit Tap #F2526 that will allow you to get power from a…
view full answer...The most likely issue is a blown or missing fuse for the trailer lighting. Locate the fuse panel under the hood, on the driver's side, near the fender. Your Owner's Manual can additionally provide you a picture of the location and…
view full answer...For your 3,500 lb Dexter Torsion axles, you will want to use the Torflex Lift Kit - Tandem Axle - 2-5/8" Lift #K71-707-02. This will provide an additional 2-5/8" clearance. The distance between the mounting bolts is 8 inches center on…
view full answer...For your 2003 Sun Valley RoadRunner travel trailer, the #10 torflex axle will use lift kit #K71-707-01 if your axle is rated for 2,300 to 4,000 lbs. If you have a #9 Torflex axle with 2,000 lb capacity then you will want #K71-723-01. We also tandem…
view full answer...You'll need an adapter, but yes, your Echo PB-9010 will work with the Rack'Em Lockable Blower Rack for Utility Trailers #RA-19. All you'll need to do is add the Rack'Em Backpack Blower Adapter #RA-STIHL.
view full answer...You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…
view full answer...If you have 12 volt lights in your trailer that you are wanting to power with your trailer's battery all you need to do is run the power and ground to the battery. When your tow vehicle is connected they will either be powered by the 12 volt…
view full answer...The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…
view full answer...Filters
- 2 results
Vehicle Fit