1998  x   >   !Land Rover  x   >   Performance Tool  x   >  

I want to connect a 7 pin to my 98 Ford Expedition. I found the connector under the dash, next to the computer diagnostic port. Where underneath the rear of the vehicle would I find the connection for the 7 pin? Thanks | There are three different...

My camper has wood on the bottom will this liner let water pass through or will the camper be sitting in water? | I have a great solution for you. I called my contact at DeeZee, and they confirmed that the DeeZee Custom-Fit Truck Bed Mat # DZ86973...

I bought a Tekonsha P3 controller from you a while back and have since put it in my 1998 Chevy K2500 to pull my horse trailer. I ran the white wire to ground, black to power with a 20amp breaker installed in line,red to the brake switch which...

I wired up the brake controller, I also checked the wiring 3 times. After I hooked up brake controller I noticed my brake lights were on I disconnected the red stop light wire and found it is hot, thus powering the brake lights. thoughts | The...

! have a 1998 Gr. Voyager with this harness installed. All lights on the vehicle work properly however my trailers passenger side brake light works but not the blinker same bulb?. I have narrowed this down to the vehicle or harness as the...

Sent truck in to have frame repaired where i bent it from hauling to much weight. Had shop replace hitch get it back and when i hit brakes and a turn signal is on both side blink? i see the black and white from truck are loose. and the purple...

I need help wiring my tekonsha voyager to my 1998 ford explorer. I installed the hitch and other than that Im starting scratch. I know the lighting harness is umber the driver side brake light. What do I need from your store? Do u have a...

The van came with the towing package a flat 4 connection. Over the years, the wires broke off and the flat 4 came off. I have the light green, yellow, and Brown from the left side in the back. I have a white and 2 browns from the right side....

I have to replace the vehicle-to-trailer connector on my Grand Cherokee Laredo 98. It has 5 wires that turns into a 4-flat connector. Colors are: Red Green Yellow Brown White I have a Vehicle wiring harness from your company- it only has Gr/Br/Ye/White...

Will this fit in my 98 tahoe? And what will i need to install it? I wanna have the 7 round and 4 flat plug at the back | You certainly can install the Draw-Tite Activator IV # 5504 in your 1998 Chevrolet Tahoe. We do have all of the products...

Hey Im replacing the 7 blade plug in my 1998 tahoe. I bought a new hopkins #1200484085 but the wiring on my truck has some different colors. I have one light green and one dark, one yellow, one red, one blue, and a white wire. cant find...

my trailer brakes are applied when the pedal is not pressed. Pressing the brake pedal releases the trailer brakes I have a 91 k2500 chevy truck, with 6 lug wheels. | It sounds as if you have the wrong wire spliced into the red wire on your brake...

I was able to locate the connection point....at least I believe it is the connection point... It was NOT under the vehicle and I was hating the Idea of having to wire all the way up to the battery. But then I removed both tail light housings...

have a Reliance controller with no plug. 1998 k2500 chey truck. I have the code from the controller telling me that the trailer is not connected even though it is and the brakes are working. the controller is not adjusting the brakes. I...

I have a 1999 Chevy truck wired with a 7 blade style connector for my camper. All work fine including center pin used as a charging line for the camper battery on my camper and several others that I move around from time to time. Recently tried...

Ive installed wiring kit 43475 in my 1998 Toyota Sienna. After plugging in the trailer, the left turn signal make the right trailer light flash, and the right turn signal does nothing. I think I followed the directions, but I wonder, could...

When connected to my trailer. My brake lights and turn signals work but when I turn on taillights nothing works | Typically when something like this happens, it will mean you have a bad ground somewhere. This can be on either your truck or your...

Im looking for a custom harness for the 1998 jeep grand cherokee with the tow package. I want to move my brake controller between my explorer and my jeep. Is there a custom harness for my old jeep? Is part number TK93VR compatible with the 1998...

I want to install a brake controller in my 1998 T100 pickup. Ive researched for hours but havent found how to do it. On your site Ive set the filter to 1998 Toyota T100 Pickup Brake Controller, but no-where in my T100 cab is there an adapter...

I tow two different trailers. one seems to work great and the other one had problems with the breaks. I removed the break wire. But my question is on my truck wiring. should the break pin have power to it all the time? I dont understand. the...

I have a 98 gmc Jimmy with automatic lights at night. When my truck light are off during the day the lights on the trailer work fine. At night when my truck lights are on the trailer lights are on as well, but when I hit the breaks all if my...

Please help me, I need a brake controller and hopefully a wiring adapter for a 1998 Ford Ranger 4.0 liter engine, 4x4 Xlt ext cab truck, I am pulling a 17ft camper weighing 2750 dry weight. I am almost sure it has the towing package, It...

Ive got an existing brake controller, Curt 50120. Can I just plug this controller into the existing harness or will I need additional wiring? | I believe that you have an older version of the CURT Discovery brake controller. The CURT controller...

I have a 98 F-150 with factory tow package. I am using a Tekonsha Voyager brake control my problem is during a recent trip I encountered an intermittent problem of aplying the brakes and having no trailer brakes even though the led on the Voyager...