Result: Step Support

I have an RV with the 2010 Lippert Coach Step LCI # 163033 which is no longer made or supported. | I have an RV with the 2010 Lippert Coach Step LCI # 163033 which is no longer made or supported....

Upon reading all the information, I do agree with you and believe the controller to be the issue. For your Replacement Steps, Motor, and Control for Kwikee RV Electric Steps # LC3722615, the correct replacement control module is the: -Replacement Control Unit for Kwikee Electric RV Steps # LC379146. |

Once the truck step # HE4045 is inserted into a trailer hitch the telescoping support arm will sit 1-5/8 inches below the hitch receiver opening and the support arm,when it is completely retracted under the vehicle, will extend under the vehicle 22-1/2 inches from the front of the hitch receiver. |

This is because the handrail will use mounting brackets specific to the TorkLift step design. In order to use this with the electric steps on your Holiday Rambler RV, you would likely need to extend the vertical rail down to the ground with a rubber foot. |

| The Replacement Step, Motor, and Control for Kwikee RV Electric Steps part # LC3747452 comes with the Replacement Control Unit for Kwikee Electric RV Steps part # LC379146. |

From the bottom of the ladder to the bottom of the first step on RV ladder # SP502L is approximately 10 inches. | what is the measurement from bottom of ladder where it attaches to trailer and bottom of 1st...

Hey Frederic, yes the Lippert Electric Tread Lite Step for RVs # LC353542 that you referenced will work great to replace the Kwikee Series 28 steps you have on your 2014 Thor Chateau 33SW. ...

With that said, you'll likely need something like the Replacement Step Frame for Kwikee RV Electric Steps - 32 Series - 24" Wide # LC3722618, which is just the step frame. ...

Will horizontal support bar fit on radrover step-thru,so that Hollywood rack can be used | Will horizontal support bar fit on radrover step-thru,so that Hollywood rack can be used | Yes. You can use the Swagman...

Both of which more than support your Aventon Aventure fat tire e-bike. Since you have the step-over style, the clamps used for mounting should be able to reach the bar for attachment just fine. | I have an...

This would be my choice, but if there is not enough overhang, then step down to the Solera RV Slide-Out Awning - 14'1" wide with a 48" projection, # LCV000163302 for white or # LCV000168112 for black, has an actual awning rail width of 169" for a 1" overhang. |

As with any flat tow setup, make sure you check your owners manual and follow all of the steps in the recreational towing section. Do you plan to install this yourself? | I have a 2025 Ford Ranger. I want to set it up to flat...

They should be two rungs lower to allow you to safely step sideways onto / off of your RV roof. Watch any regular ladder safety video to see what I mean. | Any easy way to move the ladder hooks? They should...

What do you I need to make this work. My RV has 4 pin flat. | Custer Wireless LED Tow Bar Light - Weatherproof - Magnetic Base - 23inch Long - 4-Pin Round Item # LIW-LDTL I did not realize this is sold with a 4 pin round connector....

Just make sure you follow all the steps and procedures listed in your owners manual. | I need verification on the base plate for the 2025 Ford Ranger. Does that fit the Raptor series and please verify the 2025 Ford Ranger...

I want to set it up to be towed behind RV. | Do you have a kit that will work with a 1989 ford ranger? I want to set it up to be towed behind RV. | We can help you with the items you'll need to flat tow your 1989 Ford Ranger...