Result: Step Support

Hey Karen, The Replacement Grab Handle for MORryde StepAbove RV Steps # MR72UR you were looking is designed to work with all models of the MORryde StepAbove RV Steps so it would be the correct replacement for your # MR28RR (STP-213) steps. |

| The TorkLift GlowStep Revolution Scissor Steps # TLA8004 that you referenced are designed to fit entry heights on RVs that are between 32-1/2 and 44 inches which which might be a little higher than what you have on your 2018 Lance 1475 based on the pictures I was able to find online of it, we don't have a way to get the exact threshold height of your RV so you'll have to take a quick measurement to verify. |

I included a link to the step by step instructions for you too. | I want to install the safari light bar on my 2003 Toyota Highlander and under my car cover my frame is some sort of plastic cover or skid plate...

Have a Radcity3 step through, like the Yakima hold up bike rack. | Have a Radcity3 step through, like the Yakima hold up bike rack. Would it be possible to put the bike on backwards so the vertical support would clamp down...

Is a top adapter bar needed to use this bike carrier with a 2020 Verve+Low Step electric bike or is there a better carrier you would recommend? | Is a top adapter bar needed to use this bike carrier with a 2020 Verve+Low Step...

I've attached a video below where Connor will walk you through the installation process of the # ETBC7 step by step as well as a video where David will walk you through the installation of the Redarc Tow-Pro....

The Curt 7-way part # C57674 that you referenced does work with a Pollack 7-way as they are both designed to fit the standard 7-ways found on RVs, trailers, etc. The hitch step you mentioned though was discontinued a few years back. |

Unless it is severely bent (cracks or chipped paint can indicate it is unsafe) you can bend it back and get your hitch installed. You can use a vise, step, or even some boards to bend it back. I have attached an article below which covers all of these methods for your reference. |

This is a very common step for the install of trailer hitches. Basically you just have to slide the exhaust hanger off and guide the hitch in. | We have a 2021 toyota highlander xse with twin tip exhaust and are looking to...

What I recommend is to put in a hitch cover to make the receiver more noticeable such as a chrome cover, # F-10P, or even something functional like a step, # CR-600. | In the photo provided,...

Is this a brand-new installation, or has the T-Connector been installed for awhile? As a first step, I would recommend trying a different trailer, if possible. | I have Curt T-Connector C56107 on my Toyota Highlander 2007. Unfortunately...

If you do not, you may still have one that didn't come with the 4-pole connector so continue to the next steps. Pull up on the tabs connecting the floor covering and the bottom panel. | HOW CAN I FIND OUT...

I have also attached a help article which covers some additional troubleshooting steps for wiring installations that you may want to take a look at. | I have attached the pics of my system. It already has a...

I need to install a 7 pin rv wiring harness in my 2015 Toyota Highlander XLE. | I need to install a 7 pin rv wiring harness in my 2015 Toyota Highlander XLE. I do not have the towing package. Do I need to install a custom highlander...

The installation process is straight-forward and the installation videos I attached do a great job walking through the steps. I'd start with the # ETBC7L install video and then the # C51180 video. | I own a 2018 Toyota Highlander...