Result: pop

Can i use the blue aux circuit to charge the battery on the pop up trailer? | Typically, the blue wire on a 6-way connector is used to carry the output voltage from the brake controller. The 12-volt auxiliary feed, which usually feeds the...

I emailed few weeks ago about what AMP fuse/breaker to use from vehicle battery to pop-up trailer connector to charge trailers battery. I was advised 20amp in-line fuse. But in some of your QandA they advise 40amp in-line breaker. Which one...

Will this toggle switch be sufficient to carry the amps for a winch on a Star Craft pop up using a 12 volt marine battery my toggle switch is failing when i raise or lower my pop up thanks. | I wish I could say yes, but winches can sometimes...

I have a 1976 Jayco Eagle pop up trailer that I need to replace the wiring harness its a 4 way harness. What do we need to do? | Replacing the wiring harness on your 1976 Jayco Eagle pop up trailer should be fairly easy. If your trailer is...

My Son has a 2012 Jeep compass that has NO trailer hook up nor a hitch. He purchased a small pop up camper that has electric brake on axle and would like to know if possible to put a brake controller and electric hook up on his Jeep. If so...

I have a 2006 Chevy Colorado with a 4 wire flat connection and I need to find an adapter for a 2000 model Viking pop-up that has is a 6 wire rectangle. Is there such an adapter or do I need to buy the other 4 wire flat to fit my truck and cut...

Product 118412 wiring harness is designed for use in the Toyota RAV4. The plug is a four prong flat and my pop-up camper has a 6 prong flat connection. The camper refridgerator can be run off the camper 12 volt battery while towing, but the...

Hi I just finished connecting the wiring harness and connector to my 2014 Honda pilot.When testing the power on the pins the tester showed power for the tail lights for a few seconds than I heard a sound and no power since than .The signals...

Hi I purchased N118541 wire harness to my 2012 kia sorento your video and harness was easy to install but I do have a question ever since I installed my harness I purchased a pop up trailer that has a 6 pin male plug I guess from what I couldnt...

Have a 2013 Honda pilot with factory hitch and 7 wire plug by bumper. Planing to set up pulling a pop up camper which has a 7 wire male plug with only 4 wires used. Can I buy just the one pigtail and 7 post receiver from your part number 118265?...

will this part work for the jayco style 6 square adapter used on an coleman fleet wood pop up camper thansk | Coleman used their own proprietary 6-way square connector, and from what I understand, it was only available from them. My contact...

My pop-up camper has brakes, and uses a 7-way blade trailer connector. What do I need to install a 7-way on my 2020 Outback Wagon? | Since your pop-up has brakes, you'll need to install a brake controller to actuate it. The easiest way to...

Is there a trailer brake controller for pop up camper that can be moved between 2014 Subaru Outback and 2007 Toyota Sienna? IE can the wiring be installed in each vehicle and the controller plug/unplug from each vehicle as needed. | If you...

My Tow Vehicle has 7-pole round connector. My Coachmen pop-up trailer has 6-pole square connector with electric breaks. I have 6-pole square to 4-pole flat not in use. Do I need to get this # 37995 with PK12706 to make it works? Or only...

I have a question about the Yellow wire on the # 30717. I have read that it is for Auxillary power. What do you connect it to and once connected, what gets the Auxillary Power? The TV is a Chevy Express Van and the Trailer is a Pop-Up. Thanks...

Ive recently purchased a popup trailer with a 7-pin connector. My 2008 Subaru Outback has a 4-pin connector. Ive wired up an adapter from a Pollack 12-705 receptacle and a 4-pin plug this works perfectly to control the tail lights, brake...

Have a 2018 Silverado 2500HD, 2000 Sun-Light pop up pick up camper. Pop has round 4 pin. I know I need to feed clearance lights on camper, etc. Where does power come from on truck to feed camper? | If you have a 7 Way connection, the 2 o'clock...

I am rewiring the clearance lights on a 1985 Scamper pickup pop up camper. I have noticed several semi trailers that have brake only lights in the area of the center 3 80 inch clearance lights. Thats great when you are 3 cars back and cant...

I just purchased a 1995 Coleman by Fleetwood pop-up camper, model: cedar. It does not have any trailer brakes, but I was thinking I would like some. What all do I need? The tires size is: 5.70/8 Load range C with a 5 lug rim. Now, I was also...

I am looking for advice on 3 solutions. Hitch, Wiring Harness and Trailer Brake for 2008 Chrysler Town and Country. My requirements are towing either my 2400# popup camper with electric brakes or my 2400# boat. One trailer has 4way wiring...

I need to add a Class 3 hitch to our 2015 RAV4. I am looking at the etrailer model. What do I need to purchase as far as the wiring is concerned to complete the job? We will be pulling a pop-up camper that has a 7 prong plug the pop-up has...

I recently bought a 1980 Coleman ticonderoga pop up camper and when I plug it into my 2014 tundra, all lights work as normal except for the reverse lights stay on, and the right rear wont blink for turn signal, or work for break light. Left...

Hi, Im looking for a hitch and a wiring harness to tow a pop up camper with my 2007 town and country touring. It currently has no towing package. Pop up needs a pos and neg along with the normal four wires. I have to replace the trailer harness...

I have a 2008 Toyota Highlander Sport. I am planning on installing a hitch, wiring, and electric brake to pull a 3,000 pound pop-up camper or a 2,000 pound jet ski trailer. The pop-up camper has electric brakes. The wiring harness that is...