Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire
I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Determining Correct Suspension Enhancement For 2013 Nissan Juke SV
I finally had opportunity to measure spring the gap is 1 1/8" spacing between coils | I may have another option but unfortunately there are no Timbren or Firestone suspension enhancement options confirmed to fit your 2013 Nissan Juke SV. The...
Availability of 1-1/4 inch to 2 inch Hitch Adapter that Fits 2014 Nissan Juke
I have a class 1 etrailer hitch with a 1 1/4inch receiver and I need to convert to 2. I recently purchased a class 2 from you, so I will be returning it. What anti-rattle locking hitch pins do I need? Thanks so much, | We have a Class I...
Troubleshooting Trailer Wiring When Connecting a 4 Flat Vehicle Side to 4 Flat-5 Wire Trailer
I have a 2001 Isuzu Rodeo and was recently trying to connect the connector wires to my trailer. My Rodeo is setup to use a 4 flat female end that runs to 4 wires Ground, Tail, L Turn, R Turn to a converter that connects the 4 wires of the end...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Recommended Hitch for 2013 Nissan Juke FWD
My Juke is not AWD is this hitch only for AWD or does it include AWD models. If it is olny for AWD can you provide me with model that is not for AWD. | The Draw-Tite Class I hitch you referenced, part # 24867 is indeed a fit for AWD Juke models...
Trailer Hitch and Cargo Carrier Recommendation for a 2013 Nissan Juke
It is soooo expensive to add roof racks to the Juke! How frustrating! Are there any rear carrier racks used with hitch that would fit this car?? | We do have trailer hitches and hitch mount cargo carriers that are compatible with your 2013 Nissan...
Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...
Comparing Curt and Draw-Tite Hitches for 2012 Nissan Juke AWD
I want to order a hitch for my 2012 Nissan Juke awd and it shows two different styles I was wondering what the difference is | Hi Michael; the Curt # C11088 and the Draw-Tite # 24867 are incredibly similar. They both have the same 1-1/4" receiver...
Recommended Hitch for a FWD 2017 Nissan Juke
Good morning. Can you recommend me a hitch to pull a 950 lbs camper for my Nissan Juke 2017 fwd | Hey Alain! To tow a trailer with your FWD 2017 Nissan Juke, I recommend the Curt Hitch item # 24892. This hitch is custom fit and bolts to your...
Adding a Trailer Battery to an Enclosed Cargo Trailer
I am redoing a 21 ft enclosed cargo trailer. I am rewiring 120 volt and 12 volt system. I am trying to figure what I need so that when my trailer is unhooked from vehicle I can still use the 12 volt lights etc what do I need to do this from...
Can a 3-Wire to 2-Wire Trailer Wiring Harness Converter be Bypassed
can i by-pass a 3 to 2 wire taillight converter in any way | The only way to bypass a 3-wire to 2-wire trailer wiring harness converter (assuming your vehicle has a 3-wire or separate tail light system) would be to convert your trailer to a...
Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...
Constant Power on 4-Way After Installing Trailer Wiring Harness on a 2013 Nissan Juke
I have a 2013 Nissan Juke Nismo AWD. I finally finished installing my wiring harness, but when I turn on the car and plug in a flat 4 wire tester which provides accurate results on another vehicle the left turn signal and tail light indicators...
Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer
Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...
Where is Connector Found on 2001 Isuzu Rodeo for Installing Hopkins Trailer Wiring Kit HM43215
I cannot see the plug you guys talk about in the jack compartment, however there is a similar plug on the bottom beside the spare tire is that the correct plug, and do I have to do any other connections? | The plug you have found is the correct...
Wheel Offset For 12 Inch Trailer Wheels
What is the wheel offset and is there options for the wheel offset. | The Dexstar Steel Mini Mod Trailer Wheel - 12" x 4" Rim - 5 on 4-1/2 - Chrome # AM20152 has no offset or a zero offset. Most trailer wheels are a zero offset. We currently...
Recommended Complete Flat Towing Setup For 2015 Nissan Juke AWD
2015 Nissan Juke AWD. I need to know the best tow bar, hitch and wiring for said vehicle. Thank you. | For your 2015 Nissan Juke AWD, I recommend the Blue Ox Base Plate Kit - Removable Arms # BX1851. I strongly suggest using the Loctite Threadlocker...
Exhaust Rattles After Installing Curt Hitch C11302 On a 2013 Nissan Juke
Exhaust rattle is awful below 1000 rpm. What is the best way to stop the rattle. Muffler seems pretty smug against hitch and I am hesitant to bend the post to the muffler because it might be a lot of bending. | It sounds like you already know...
4-Way Trailer Wiring Recommendation for 2002 Isuzu Rodeo
HI first Id like to thank you for you time to answer my question. Ok I have a 2002 Isuzu Rodeo and I want to install a 4way trailer conception. But I only see a connecter with 2 wires one hot and on ground I believe they are the running lights...
Methods to Avoid Trunk-Mount Bike Carrier from Damaging Paint Finish on Vehicle
We are looking at a Saris Bone 3 and are concerned about the hooks scratching the paint on the car at point of contact. Is there a way to protect the paint or is there another rack that you would recommend for our 2014 Juke? | Any trunk-mount...
Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....
Trailer Hitch for a 2012 Mercedes R350 BlueTec
Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...
Filter Your Search
Contact and Help