bing tracking image

RTV  x   >   Rondo  x   >   RVR  x   >   Venture  x   >  

Why Choose a Powered Taillight Converter Over a Non-Powered Model

What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...

Replacement Motor for Lippert Kwikee 32 Series Steps on 1997 Winnebago

what is the step gear and motor replacement for a 1997 Winnebago adventurer 32 | Although I managed to find an online owner's manual for your 1997 Winnebago Adventurer, it did not specify the specific steps that you have. The Winnebago manual...

Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter

Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...

Availability of Tire Chains for 17.5L-24 Tractor Tires for Kubota MX5100

hi do you have chains to fit my 17.5L-24 tractor tires? not sure how to use your search tool for this application - kubota MX5100 4wd thanks | Hi Glenn; we do have tire chains that for your 17.5L-25 tires on your Kubota MX5100. The search...

Finding Installer for Curt Hitch on 2009 Kia Rondo

A Curt Trailer Hitch Receiver for a Kia rondo 2009 what car brands aré compatible to install the tráiler Hitch | Hey Adrian, I attached a link to an installer locater that you can use to find someone to install the Curt hitch part # C11031 on...

Parts Needed to Add Brakes to 1992 Coleman Arcadia Pop-Up Camper

I want to add brakes to my 92 Coleman Arcadia pop-up. I am looking for the correct hub/drum and electric brake assemblies. The wheel bolts are 5 on 4 1/2 and the tires are Carlisle USA Trail 20.5x8-10. The current axle includes a square flange...

Leaf Spring Recommendation for a Trailer to Stiffen Up Suspension that has 3,500 lb Axles

I have a boat trailer with a single 3500 LBS axle. It has the factory 3 leaf springs. With the boat on the trailer, the trailer seems to nearly bottom out on some highways. The load in the boat should not be considered overloaded. Would going...

4 Pole Trailer Connector on a 2004 Chevy Venture

I installed a hitch and reese wiring kit on my 04 Chevy Venture. The wiring instructions are not great. Not much help in the steps to removing the interior trim, and mine has rear air which is not mentioned in the instructions. What do I do...

Can Second Axle be Added to Enclosed Snowmobile Trailer

I have an 8x12 hybrid enclosed snowmobile trailer with a single 3500lb idler axle. I’d like to add a second axle forward of the one it comes with. Can I safely add another axle? How do I determine the optimal placement? Will a second axle...

Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross

I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |

Location of Factory Connection Point for Trailer Wiring Harness on a 2003 Chevy Venture

Trying to install your c55355 for 2003 Chevrolet Venture Van. I cant find the trailer wiring harness plug. Ive looked at the cable bundle behind the panel and simply cant find the plug. I note that you have a video for 2002 and 2004 but not...

Tire Chains for an ATV with 25x10x12 Tires

Are cable chains available for Kubota SUV... 25X10.00-12NHS | While we do not have cable chains for ATV 25x10x12 tires, we do have low-carbon steel V-bar chains for them. They are the Titan Chain ATV Snow Tire Chains - Ladder Pattern, part...

Recommended Trailer Hitch Receiver for 2011 Kia Rondo

I am looking for a trailer hitch for my KIA Rondo 2011. Do you guys have anything for this models Thanks | For a trailer hitch that fits your 2011 Kia Rondo we have the Draw-Tite Trailer Hitch Receiver # 36525. This is a custom fit Class I...

How to Identify Replacement Bearings, Races and Seals for Harbor Freight Trailer 92174

Recommendation for a Harbor Freight Trailer 92174 replacement bearings/seal? | The best way to determine the replacement bearing, race and seal parts needed for a trailer is to pull one of the hubs and remove them so their part numbers can be...

Wire Gauge and Circuit Breaker Needed to Wire 12 Volt Accessory Circuit to Trailer Connector

Ive not read the details in the wiring of the black 10 gauge wire that goes to the rv 12 volt battery. Ive read about using 10 gauge wiring and that it should be fused but how muchamps, and what kindslow.fast or reset. Im towing a 2000lb popup...

Trailer Hitch Recommendation for a 2007 Kia Rondo

I am looking for a trailer hitch for a Kia Rondo that was manufactured in Dec, 2006. I dont see one in your listing earlier than 2007. Thank You | That is because you most likely have a model year 2007 Kia Rondo that happened to be built in...

Setting Up a 2004 Chevrolet Venture to Tow a 2,500 Pound Camper with Trailer Brakes

I would like to pull an ultra light 16 Camper with this van. I need a class III hitch, but do I need air bags installed? The camper weighs about 2,500 lbs. dry and we plan on pulling it about 500 miles both ways on Michigan roads. We also...

Troubleshooting Rhino-Rack Roof Rack Installation on 2018 Mitsubishi RVR Flush Rails

Ive tried to install the kit of the SX031 legs on my 2018 RVR, but if you look at the pics those legs are not straight on the flush rails so when I have the bars on them then they dont fit anymore... Am I doing something wrong or I got the wrong...

Wiring Harness With Easy Install For 2009 Kia Rondo

I am interested in the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector for a 2009 Kia Rondo. One of the issues I see in the reviews is that the green wire from the drivers side to the passenger side can be too short....

Where is the Trailer Wiring Connection Location on a 2000 Chevy Venture

I have torn the inside of drivers side trim completely out of my van to find where the plugin is suppose to be.The only thing I can find that even looks like it might work is at the tail light itself.Will you please help me? | On a 2000 Chevy...

Availability of High Capacity Trailer Hitch that Will fit 34 inch Frame Measured From Outsides

I have a 1098 Renegade toterhome and stacker trailer. I am looking for the highest rated 30-40 thousand lb rating. I have talked to forklift but the person that I talked to was not very knowledgeable. Do you stock a hitch that would fit this...

Best Compatible ATV Winch and Mounting Plate for a 2012 Kubota 900XT RTV

What model winch would you recommend for a Kubota 2012 900XT RTV, do I need to purchase a separate mounting plate? This would only be used occasionally. | Yes, you will need to purchase a separate mounting plate specifically designed for your...

Trailer Right Turn Signal Not Working When Connected To 2004 Chevy Venture

I have a 2004 Venture mini van. I had a problem with the lights on a trailer I have. I had to rewire most of it. When I new I had it right on the trailer I plugged in the Venture van. Everything worked except the right turn signal. I also have...

Will The Torklift StableLoad # TLA7311 Work With An Air Bag Kit?

Will the StableLoad - A7311 work with air bags. If not is there any other equivalent options? | Yes, the Torklift StableLoad # TLA7311 will indeed work with an air bag kit. This is actually a combination we recommend fairly frequently as the...

Filter Your Search