Bias tire has a ply rating of 10 and a 1,650-lb maximum load at 90 psi. The 10" diameter x 6" wide steel trailer wheel features a 5 on 4-1/2 bolt pattern and a corrosion-resistant galvanized finish.
Bias tire has a ply rating of 8 and a 1,165-lb maximum load at 70 psi. The 8" diameter x 7" wide steel trailer wheel features a 5 on 4-1/2 bolt pattern and a corrosion-resistant galvanized finish.
The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the…
The 1-7/8 inch width is what is rounded up to 2 inches which is a standard width for winch straps. The 14 foot length is not something we carry. I recommend the Hand Winch Strap with Safety Hook, 2" Wide x 15' Long - 4,000 lbs…
The #37213635 JR Products Replacement Landing Gear Switch you'd mentioned would be a proper replacement for your existing Atwood 70254 landing gear switch. If you wanted the switch, wiring harness and the bezel for the switch, use the…
While we have the measurements of the exact ground clearance height for our hitches we carry for a 2022 Toyota Sienna, we do have available measurements for a 2021 model. While these are not exact, the measurements will not deviate much from the…
The serial number and VIN are typically printed on a label or plate placed somewhere on the trailer's pole tongue, although it could possibly found elsewhere on the trailer frame, possibly on the inside edge of the frame so it's more…
To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…
The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…
The majority of electric a-frame trailer tongue jacks will have a 3,500 lb weight capacity which is most likely what your old Atwood jack is. If not, the 3,500 lb capacity will be more than enough for you because it only needs to be rated for the…
The Demco Hydraulic Brake Actuator #DM72VR will replace your Atwood 171 actuator. This surge brake actuator will work for drum brakes and has no reverse lock out but is recommended that you equip your trailer with free-backing brakes so you can drive…
No sweat! You'll just need to install a 12-volt outlet kit, part #RM-9332. The socket would be located under the dash, so you can easily locate it to plug in the Patriot. The outlet would wire directly to the vehicle's battery. Each time you…
The 171317 steps are no longer being manufactured, but we do have a replacement gear plate as part #LC301696, motor part #LC301695, and controller part #LC301702.
Filter Results
