Can The 7-Way Trailer Connection Be Used To Power Winch If Vehicle Is Running
Can the 7 pin plug be used to power the winch if I have my truck running? | The wiring that feeds the 12-volt accessory circuit on the 7-way trailer connector is of too small a gauge to allow enough power to pass through to run a winch. The...
Does Power Grip RV Temporary Power Cord Extension Require Adapters
Our Camper has a 25 foot built in cord but not long enough to connect at a particular site we like. Will this extension fit on the end without the need for a special adapter? If an adapter is needed can you recommend? | The Power Grip RV Temporary...
Recommended Snow Tire Chains For My 2004 Lexus ES 330
My Lexus es 330 has tires 215/60 r16. Shur Grip tire chains box doesnt show this size but does have 215/60 r15. Can I use it? | I took a look at the Shur Grip tire chains and we do have tire chains that are similar to fit your 2004 Lexus ES...
Does The Draw-Tite Trailer Hitch Receiver # 36336 Require All 4 Drivers Bolt Holes To Be Used?
Hello, in my 2005 ES330, there appears with one hole already drilled on the driver side rear frame with a black plastic cover. Do I need to drill another hole? In the video, the last hole was left open without a bolt. Is it safe to have only...
What Size Dowel Nuts Do I Need for My Vehicle?
Where can I find the dowel nut replacement bolt for gutter mount. Its for an 1996 landcruiser | We do have plenty of replacement dowel nuts like the Replacement M6 x 16 mm Dowel Nut for Rhino-Rack Accessories # RR56TB which are M6 x 16 mm threaded...
Tips for Trailer Hitch that Won't Line Up Totally with Install Holes
I recently purchased a Draw-Tite Trailer Hitch Receiver Class II - 1-1/4 for my 2006 Lexus ES330. I have managed to get 4 of the 5 bolts in. But the opening for the 5th bolt the forward-most bolt on the driver side does not quite line up...
Aero Roof Rack Recommendation for 2004 Lexus ES 330
Hello, Im interested in the Whispbar Flush Bar Roof Rack for the Lexus ES330. What are the appropriate hardware needed to install it. If possible, I need to know what Size Whispbar I need and what kit to mount on the the roof with something...
Is Drilling Required to Install a Draw-Tite Hitch on a 2004 Lexus ES330
Hello, Do I need to drill holes on my car to install the hitch or are there holes already available on a 2004 Lexus ES330 to attached the hitch? | The Draw-Tite # 36336 is a custom fit hitch that is designed to fit on the frame of your vehicle,...
Recommended Tire Chains For Off-Road And Snow Use On 1996 Lexus LX450
Please recommend snow tire chains for my 1996 LEXUS LX450. The truck has a 2inch lift for additional ground and tire clearance. Tires are Goodyear Wrangler Duratrac 265/75-16. The chains will be used on four wheels on snow and ice covered paved...
Left Signal on Trailer Flashes when I Indicate Right Turn
I have a 96foot LX450. When I signal a left turn all works as it should. When I signal right, the lights on the right side passenger side of the trailer go out and the left turn signal blinks on the trailer. All the lights work properly on...
Do Factory Bump Stops have to Be Cut to Install Air Lift Air Bags on a 1997 Lexus LX450
Hi! Do I need to hack off part of the bump stop for this installation? Please send install procedure specific for a 1997 Lexus LX450. | Yes you will need to trim away the factory bump stops to install Air Lift helper springs # AL60728 on your...
Brake Controller Installation on 1997 Lexus LX 450
looking for a Prodigy direct plug in wiring harness for a 1997 Lexus LX450. Do they make one or do I have to use a universal and wire it myself? | The 1997 Lexus LX450 was not factory equipped with the connector under the dash for a plug and...
Replacement Windshield Wiper Blades for 1997 Lexus LX 450
Why is one 16inches and one 18inches when both should be 18? 1997 lx 450 is the vehicle. is the scrubblade bigger? and has clearance issues? | Actually, Scrubblade recommends the # SC87FR 18 inch blade for the driver side and the # SC67FR 16...
2011 Jayco Jay Feather Tire and Wheel Replacement Recommendation
2011 Jayco Jay Feather tire and wheel replacement Just bought this camper and prior owner thinks these tires are original so Im thinking of replacing them. They are.. ST205/75 R14 The tire says Do Not Mount on a 14.5 inch Rim Load Range...
Recommended Cover for 22' Jayco Travel Trailer for 6 Months Storage in Connecticut
always have had a adco cover the item # 290-52242 looks good, it says for rain and snow, but to be used between trips. well i am covering it for 6 months threw the winter, is it ok for that length of time, this is not short term, i like that...
Availability Of Lift Kit For 2011 Jayco Jay Feather Ultra Lift W/ # 10 Dexter Torflex Axle
Do you guys have a lift kit that is bigger then 2 5/8?this trailer has no clearance and Im replacing Jacks all the time. | Since your 2011 Jayco Jay Feather Ultra Lite X17Z has a # 10 Dexter Torflex axle the only lift kit available for it is...
Installing the Hopkins Smart Hitch Backup Camera on a 2013 Ram
I have this camera but it doesnt work on my 2013 Ram. Why not? | We have learned that the 2013 and newer Ram trucks do not provide enough voltage to power the Hopkins Smart Hitch, part # HM50002, simply by plugging it in to your truck. In...
Comparing the Draw-Tite and Curt Trailer Hitch for a 2004 Lexus ES 330
Hello, I have a 2004 Lexus ES330. You folks show 2 hitches as fitting and both go around the exhaust. Which of the 2 provides the greater ground clearance? Thanks | Both the Draw-Tite # 36336 and the Curt # C12339 will essentially have the...
Trailer Wiring Harness Recommendation for 2004 Lexus ES 330
Hello - looks like I need to be able to tow a small trailer in the coming weeks. I have the hitch on the car, but need the harness. I know for the most part that the 2004 Lexus ES 330 is effectively a Toyota Camry. Given that, do you know...
Draw-Tite VS Curt Class III Receiver
I have a 1997 Lexus LX450 with the Draw-Tite Class III receiver installed. It has been there for quite a while and is has rusted so I thought it was time to replace it. I would like some information on Draw-Tite vs Curt for the class III receiver....
Filter Your Search
Contact and Help