What Tie Downs are Needed to Install Roadmaster Base plate Kit 1003-1 on a 1992 Suzuki Samurai
When I looked up the toe bar base plate for my Samurai it said the car must have tie downs. What are tie downs and where would I look for them? Thanks. | The base plate kit for a 1992 Suzkuki Samurai, part # 1003-1, refers to the tie down loops....
Flat-Tow Wiring for a 1988 Suzuki Samurai with Combined and Separate Signals
I have a Ready Brake surge type tow bar to pull a Samurai with custom bumper and lights. I have 4 lights, the outside lights are brake and turn signal and the inside lights are brake only. My tow bar has a mechanical brake actuator. If I wire...
What Tow Bar and Mounting Brackets Will I Need to Tow 1987 Suzuki Samurai
tow bar? what do all I need with ordering tow bar... Do the tow bars come with mounting brackets for my Suzuki if not where do I find those, and will they go with hook up style of the tow bar? Thanks | There are a few things you will need along...
How to Determine if a Trailer has a 13 inch Rim with a 4 on 4 inch Bolt Pattern
Do you have a 13 inch 4 hole rim that the bolt on holes centers are 2 3/4 inches apart? | It sounds like you have a bolt pattern of 4 on 4 inch, but the dimension you listed is slightly off from what this bolt pattern is. What you will want...
Can the Lippert Components RV Spare Tire Carrier Be Used On a Motorhome
Can I mount your spare tire carrier under a Ford F53 chassis motorhome? | The Lippert Components RV Spare Tire Carrier part # LC159041 is designed primarily for trailers so it would not be a good choice for your motorhome. The weight of the...
Do the Door Panels On a Suzuki Samurai Need Removed To Replace the Side Mirrors
Do I need to remove inner door panels to replace the side mirrors? Or can I replace them from the exterior? ‘87 Suzuki Samurai | Yes, you will need to remove the door panel most likely to replace the side mirrors on a Suzuki Samurai with the...
Will the Rampage Padded Center Console Interfere with Folding Rear Seat Back on 1986 Suzuki Samurai
Does it interfere when you fold the back seat out of the way? | The Rampage padded center console # RA34023 for the 1986 Suzuki Samurai is not supposed to interfere when folding the back seat. But if you go by its measurements you can determine...
Where Does the Roadmaster Base Plate part # 1003-1 Install on a 1986 Suzuki Samurai
1986 suzuki samuria the instructions for the baseplate 1003-1 does not mention the front bumper? does the baseplate go behind the bumper and the attaches to a tow bar? | The Roadmaster base plate kit part # 1003-1 that you referenced attaches...
Is the Bestop Replace-A-Top for the Suzuki Samuri Available in Different Colors
Gday guys just wondering where it says The top is mildew resistant, contains UV protection and comes in factory-original colors. ... what are the colors i have to choose from if any Thank you | The tops for the 1990 Suziki Samurai, see link,...
Bestop Replace-A-Top for a 1987 Suzuki Samurai
will it also fit a 87, or is there a different one for that year | You will need the Bestop Replace-A-Top for Suzuki Samurai, part # B5136115, for your 1987 Samurai. If this top is not what you are looking for, you can view all of the tops available...
Availability Of Lift Kit For 2011 Jayco Jay Feather Ultra Lift W/ # 10 Dexter Torflex Axle
Do you guys have a lift kit that is bigger then 2 5/8?this trailer has no clearance and Im replacing Jacks all the time. | Since your 2011 Jayco Jay Feather Ultra Lite X17Z has a # 10 Dexter Torflex axle the only lift kit available for it is...
Installation of TorkLift Battery Box TLA7708R on Travel Trailer with OEM Battery Tray
What becomes of the travel trailer factory installed metal framing that is welded to the A frame? Does this box fit inside that frame? Either a single or dual battery config. | The TorkLift PowerArmor Locking Battery Box # TLA7708R does not...
Flat Towing a 1990 Suzuki Samurai With Separate Tail Light Wiring
I purchased a 1990 Suzuki Samurai that has been previously wired for towing behind an RV. It is a butcher job and I will be removing it and all its splices into the OEM tail light housings and wiring. I am installing all new OEM tail light housings...
Does The Pavement Ends Replace-A-Top For Suzuki Samurai Come With Tinted Windows Or Can I Tint Them
Can the Bestop #B5136109 for my 1986 Samurai come with tinted windows or can they be tinted? THX | I contacted our representative at Bestop, and she informed me that there is not a top that comes with tinted windows for your 1986 Suzuki Samurai....
Diode Wiring Solutions for a Flat Towing a 1991 Suzuki Samarai
Hi. I have a flat four connector on my camper. I am interested to get the right kit for a 1991 Samurai. I would like to use the integrated lighting setup and eliminate magnetic lights. Questions: Looks like I can use one of two kits if...
Base Plate Fit on 1987 Suzuki Samurai With Front Leaf Springs
The instructions say to remove bolts on torsion bar mounts. The Samurai does not have torsion bars. It has front leaf springs. Where does the base plate mount with the leaf springs and what other changes are there to mount it to the vehicle?...
Difference Between 3 Terminal and 4 Terminal Solenoid
Working on aux charge solenoids on our camper. I find there are 2 types of solenoids, the 3 terminal and the 4 terminal type. I believer the 2 large terminals on both carry current from the charging location to additional batteries. If using...
Can 1987 Suzuki Samurai Spare Tire Cover be Put On with Saris Mounting Bracket Installed
Staff, I have a 1987 Samurai. With the rack removed will my tire cover fit over the spare with the mounting plate hardware installed? Thank you. | Yakima does not list the SpareRide, # Y02599, as a fit for your 1987 Suzuki Samurai so I cannot...
Roof Rack Recommendation for 1987 Suzuki Samurai
I am looking for a roof rack system for an 87 Samurai | For your 1987 Suzuki Samurai we have the Inno roof rack part numbers # INB117 and # INLD as a confirmed fit which would be an excellent choice! It's a square bar roof rack with a higher...
Does Roadmaster Base Plate for 1987 Suzuki Samurai Require Cutting Bumper
Purchased the 1003-1 base plate for my 1987 Suzuki Samurai. Do I need to cut the bumper to attach the plate to the frame? Thank you | I took a look at the installation directions of the Roadmaster Crossbar-Style Base Plate Kit # 1003-1, and...
Strong Hitch & Ball Mount Exclusive For 1986 Suzuki Samurai
I have a 1986 Suzuki Samurai. I bought a Reese tow bar, but see that I need something to attach to the frame. Can you recommend a product for me? | You have asked for a hitch that mounts directly to the frame but there is not one made for...
Base Plate Kit Recommendation for 1987 Suzuki Samurai with Roadmaster Stowmaster Tow Bar
Can I bolt 25-0174 brackets to 1003-1 Suzuki Samurai base plate and use the Stowmaster 5000? I realize the brackets would then be permanently mounted. This is not a problem. I have the brackets and Stowmaster from a previous application and...
Diameter of Hole That Runs Through Timbren Spring # TJFJ10
I need to know width of the mounting bolt holes for part number TJFJ10. Thank you | The diameter of the hole that runs down the middle of the Timbren spring of part # TJFJ10 is 1/2 inch. |
Distance Between The Mounting Tabs On A The Roadmaster Direct-Connect Base Plate Kit # 1437-3
Website shows all measurements except one thats very important. I need to know the measurement inside to inside of the tabs themselves, where the coupled goes in and pin goes through to secure. Thanks | The distance between the two tabs on the...
Filter Your Search
Contact and Help