Diameter of Hole That Runs Through Timbren Spring # TJFJ10
Updated 11/11/2020 | Published 11/09/2020
Question:
I need to know width of the mounting bolt holes for part number TJFJ10. Thank you
asked by: Paul F
0
Expert Reply:
The diameter of the hole that runs down the middle of the Timbren spring of part # TJFJ10 is 1/2 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Timbren Front or Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Front Axle Suspension Enhancement
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Do Timbren Suspension Enhancement Springs Affect Unloaded Ride Quality
- Q&A: Will The Timbren Rear Suspension System # TTORSEQ Fit 2023 Lexus GX 460 With Factory Air Suspension?
- Q&A: Timbren Suspension Kit Recommendation for 2002 Chevy S-10 ZR2
- Q&A: Is Timbren Suspension Enhancement for 2021 Ford F-450 Super Duty 4WD Compatible With 5th Wheel Hitch
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Best Way to Reduce Sway & Body Roll on 2019 Winnebago Intent 29L on Ford F-53 Chassis
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: 2020 Thor Hurricane 34R Lug Nuts
- Q&A: Recommended Front Suspension Enhancement for 2011 Thor Hurricane 32A Motorhome