How To Wire 3-Wire Fuel Transfer Pump To Vehicle 7-way Connector
You have an answer to wiring a transfer pump with two wires. How do you wire a three wire pump? White, black, and green wires to a seven pin plug. Thanks | Since your transfer pump has 3 wires that means it has a static ground. The green wire...
Taillight Lens Replacement for 2018 Sportsman 210 BHLE Travel Trailer
Taillight lens for a 2018 Sportsman 210 BHLE travel trailer | I was able to find a couple pictures of your 2018 Sportsman 210 BHLE online and from what I saw the correct taillight lens would be the part # AST61B that you referenced. |
Simple Light Needed for Horse Trailer Tack Room
Hi- I’m interested in installing more lights in my horse trailer tack room area. I am wondering what you would recommend I get as a system- I would like something that does not need shore power/truck power to run at least for a bit so I know...
How to Install 1-Wire Optronics Trailer Clearance or Side Marker Light w/ Reflector
Is there a video to show me how to replace this light? Or even something like it with the on black wire. I need help. Just bought this from you. | While we don't have a video showing how to install the Optronics Trailer Clearance or Side Marker...
Recommended Trailer Wiring Replacement For Sea Doo Trailer
I have to replace the harness on my Sea Doo trailer. Attached is the pic of the wires that my dog chewed off. Do I splice the browns together as well as the whites? | With two brown wires in your photo it indicates a wishbone harness basically...
Replacement 5-Way Flat Wiring for 2005 Four Winns Trailer
Id like to replace the wiring on my 2005 Four Winns trailer that has the blue wire for the brake actuator for backing up. What would I need? | I recommend using the 5-Pole Flat Connector # A40W5Bto rewire your 2005 Four Winns trailer. This is...
Parts Needed to Flat Tow 1997 Jeep Wangler TJ
I have a Ready Brake Brute and like to use it to tow a 1997 Jeep Wangler TJ what Would I do two the Jeep yo tow it? | A braking system like your Ready Brake and a tow bar like your Ready Brute are two of the items needed for safe and legal flat...
Is GloLight LED Trailer Clearance or Side Marker Light P2 Rated
The listing on this item says it is PC rated, but then when you click on more info it says it is P2 rated. Which is it? | I checked with Optronics and can confirm that the GloLight LED Trailer Clearance or Side Marker Light # MCL157RB is P2...
Combined Trailer Turn Signal and Side Marker Running Light for a Trailer with no Side Markers
Id like to add a side marker light to a long trailer I have that currently has no side markers. But Id like a dual circuit, so its on with headlights as a marker but has a blinker capability as well. | On a trailer, the turn signals and brake...
Looking for Replacement Trailer Lamp Lens # 1A-S-20
Is the 1A-S-20 KII the same demensions as the A32RB lens cover. I have googled it and cant find the 1A-S-20. If it is I would like to order four amber and seven red. I look forward to your reply. | I was able to find the exact replacement amber...
Availability of a 7-Way Round Pin to 5-Way Flat Trailer Connector Adapter
Ive recently replaced my 2003 Chevy Trailblazer with a 2008 Ford Explorer Sport-Trac, both vehicles were factory wired for towing. However, the 7 round plug I have for my Tailblazer is not compatible with the Ford 7 round, only the brake lights...
What is the Matching Right Hand Tail Light for Trailer Tail Light # STL17RB
Ive located your left light in this model, but cannot find the RH on your page? I need the two. I do not want to have two license lights for each side. | The matching right hand light that you will need is # STL16RB. We also have these lights...
LED Replacement Lights for Peterson M444
I am looking to upgrade the rear lights of my Car Mate 5x8foot utility trailer. I currently have Peterson PM444L lights. I am hoping to use the TLL16RK set however I am not sure if they will fit. The Petersons have the standard 2 inch center...
LED Trailer Taillight that Has Mounting Studs that are 4 inches Apart
The studs on my trailer lights are 4 inches apart. Do you have Leds to match this? | Hey Bruce, so the mounting studs of the Optronics LED Combination Trailer Tail Lights # TLL160RK that you referenced can be set exactly 4 inches apart so this...
No Left Side Stop or Turn Signal Lights on Trailer After New Harness Installed
I replaced everything and was working fine, now out of the sudden the left side stop working, signal, stop , and everything is new | The most common problem we see with intermittent function in regards to trailer lights are poor grounds....
Parts Needed to Add a Brake Controller on a 2013 Jeep Grand Cherokee With or Without the Tow Package
I have a 2013 Jeep Grand Cherokee without a factory installer tow package. I did a search on the site and found a custom fit 4-pin wiring kit, but I need a 7-blade wiring kit. Can you advise which product I would need for a 7-blade and also...
Correct Replacement Taillight for Trail Star Boat Trailer
Right side taillight is out on my trail star trailer It’s like a circuit board with no wire disconnect How do you replace it | In order to replace the taillight on a Trail Star Trailer you'd simply find one with the same style (shape/function)...
Which LED Trailer Tail Lights Fit A 2003 Shorelandr Galvanized Boat Trailer?
I need to purchase driver and passenger side LED tail lights for a 2003 ShoreLandr galvanized boat trailer. The model number is SLV20LW-00S-S and the light measures 6/3/4" wide, 3 1/2" tall and 2 1/8" thick. The bolts on the back are 2" apart....
Recommendation For LED Replacement Light For a Trucklite 45202 On An Enclosed Utility Trailer
I have an enclosed utility trailer. Currently has Trucklite 45202 lights. One is burned out. Would like to replace with LED lights. Will these work? | The Optronics Tall Rectangle LED Trailer Light, Item # STL34RB, will work for you so long...
Wiring Guide for Optronics Stop, Tail, Turn Light RVSTB60
i have submiited this question to Bargman, no response yet. see attached file. thanks. | The Optronics light you referenced in your question, part # RVSTB60 , is a 3-wire design that includes a wired ground (the white wire) rather than a...
Could Ground Wire of Optronics Trailer Taillight STL68RB Be Ran to Two Ground Circuits
Hi so I built a flatbed for my 2004 f350 and was interested in using the STL68RB all in one surface mount lights for the rear. The OEM lights have 3 wires going to the stop, tail and turn and 2 wires going to the reverse. Assuming one of the...
What Connector to Use to Attach Brake Output Circuit to Junction Box
Hooking brake wire to my junction box blue terminal. | Ring terminals like the part # 44-5310A are the best way to connect circuits like the brake output to a junction box like the # 38656. These ring terminals are what you see in the junction...
Replacement Lens for 7-3/4 x 3-1/4 Inch Optronics Trailer Tail Light
I need a replacement lens for my boat trailer. It is on the drivers side. It is an Optronics brand. The part number on the lens is SAE S2T216AP2 DOT 16. It is 3 1/4 inch X 7 3/4inch ? - broke. Thank you. | The SAE part number is not the...
Submersible Reverse Light and 7-Way Kit for Boat Trailer with 4-Way
Could you suggest a product that will allow me to add two sealed reverse lights onto a boat trailer? Trailer is currently a 4 plug harness and vehicle will except 4 or 7 round plugs. I’d prefer to keep the existing wiring harness on the trailer...
Filter Your Search
Contact and Help