!Jetta Wagon  x   >   Plymouth  x   >  

Hello, I have a 88 Plymouth Voyager w the factory towing package. Its rated to pull 3500 lbs. Whats is the easiest and most economical way to raise the rear of the Van when towing.? Normally I would not have to do this, but If I have the Van...

will a draw tite 02203 fit a 2000 grand voyager | I do have a solution for you, however the Draw-Tite model 02203 trailer hitch that you mentioned looks like an older model hitch that has since been discontinued. From what I could find, this...

I have a tow package installed on a 1998 plymouth grand voyager and I was wondering if it would fit on a 2007 dodge grand caravan. | If you have theDraw-Tite Max-Frame Trailer Hitch # 75119 on your 1998 Plymouth Grand Voyager, you will be happy...

I recently had my expensive trailer hitch stolen right off my 92 Voyager. Before I buy a replacement, is there a way I can put on some security bolts or something like that so it doesnt get stolen again? I know I can have the bolts welded...

Everything works well on the 1999 plymouth voyager and the trailer 4 pin with headlights off. With headlights on, all is correct except the brake lights do not work on the van by itself nor do the trailer brake lights when connected. Help !...

The turn signals work on the trailer but the brake light and light does not. What could be the problem. Installed this kit on a Plymouth Grand Voyager. | The best way to test the lighting functions on your 4-pole harness # 118334 is to disconnect...

What is the back spacing? And can I use this on a 72 Plymouth Valiant as a factory replacement? | Per our Dexstar contact The Dexstar 14 x 5-1/2 Inch Wheel # AM20304 has a back spacing between the range of 3.32 inches to 3.44 inches, these will...

I want to purchase a hitch for my 99 Plymouth Breeze and along with that Ill need to install a 4-prong wire for lights. I havent seen a T-connector for my particular car, and etrailer.com offers about 4 wiring harnesses for hardwiring my car....

! have a 1998 Gr. Voyager with this harness installed. All lights on the vehicle work properly however my trailers passenger side brake light works but not the blinker same bulb?. I have narrowed this down to the vehicle or harness as the...

I have the minivan named above and I have a 10 ft Pelican kayak. I want to make sure what I order is right for my van and that the items are the only required parts to put my kayak on my minivan to take to the lake. | The best way to carry your...

Will this product fit if you have the full spare tire but DONT put the spare back underneath? | The Curt # C13362 will fit perfectly if your 1998 Plymouth Voyager as long as it isn't a sport model. Once installed, the hitch won't interfere with...

The 1958 Plymouth air conditioning system uses engine oil pressure to operate vent doors via a hydraulic valve. Is the hose material usable with the engine oil? | It depends on the hose. The part that you came from, # T0778500, is a fitting....

1999 plymouth grand voyager. Im installing a trailer tow package and i need to know if i can hardwire the wires from the trailer to the tail light wires or do i need a converter. i believe i have the two wire system but would appreciate any...

Will this tail light converter work with a tow vehicle that has incandescent bulbs and a small trailer that has LED lights? | The Hopkins Vehicle Wiring Converter, part # HM48915, is used for a vehicle that will have a 3-wire system, which means...

Hi, I have installed a hitch on my 1995 Plymouth voyager, and I want to make sure it is good for towing and carrying weight, so I plan to get the suspension enhancement system, and I am wondering if a transmission cooling system is also needed....

Just double checking that the set includes 2 roof rails, 2 cross bars, and all the parts to install? Thank you | Our roof rack systems include everything you need to install it on the roof of your vehicle If your Voyager does not have raised...

Can the Dexstar AM20304 rim be used on a 1966 Satellite to match existing rims? | As long as the bolt pattern (5 on 4-1/2 inches) and offset (+.5 inches) fit then it should work. I would certainly double check your measurements and keep in...

I have a sea Ray Sundancer and I wonder if this could replace my old one? Its mounted under the counter and also runs on 12 v battery power? | The great thing about the Everchill Refrigerator for RVs # 324-000110 is that it is a universal design...

can you make a trailer hitch for my 1979 Plymouth volare? all I will be towing is my sea-doo. | We don't have a custom fit trailer hitch receiver for your 1979 Plymouth Volare. We are a retailer and not a hitch manufacturer, so we don't make...

what size tek screws do you recommend to mount these type of hangers to enclosed cargo trailers? there is a 1/4inch thick wood interior skin and then what is the size of the metal tubing behind it in a normal car hauler trailer? | The Tow-Rax...

Driver side OR passenger side installation on a 1990 Plymouth Voyager SE 3.0L? Thats all I need to know. Thank you! | Curt trailer wiring harness # C55493 plugs into a towing harness located behind the driver's side rear trim panel by the rear...

Need a plastic trailer hitch cover for a Reese hitch #79062 1996 Plymouth Neon installed 09/2001. Called the shadow. 2000 lb trailer/200lb tongue weight. | For your hitch cover on your 1996 Plymouth Neon, I recommend the etrailer.com Rubber...

Is it possible to attach a bike carrier to the cargo carrier # 63153? i can see in the pictures that there is an opening that could be use it to attach the bike carrier if the proper holes are in place. I saw in another web site that they offer...

If I want to install this to my car 98 plymouth voyager will it require drilling? | For the 1998 Plymouth Voyager, two 1/2 inch holes will need to be drilled in the bottom side of the frame member on each side of the vehicle. This is not terribly...