Result: knobs

Hi, I have the INH120 rack and lost the keys to it and the rattle knob is locked to the rack. If I order a new one with keys will those keys work with the existing knob? | Hi, I have the INH120 rack and lost...

Have power at the controller, no lights at the knob. | Have power at the controller, no lights at the knob. | I would start by using a hook probe tester like the # PTW2993 to check and see if you're getting a power feed on the...

The Locking Knob is the only think like this from Yakima that I know of. | I am planning to build a custom base bar setup to clamp to my trucks Thule SR Base rails. Im thinking of using the Inno square base bars drilled and...

I need the key for anti shake knob, My rack is INNO INH 110, purchased from you. | I need the key for anti shake knob, My rack is INNO INH 110, purchased from you. | To get the correct replacement key for the locking knob...

The Tall Crossbar Adapter Kit # INISF711 comes with the bolts only, and does not come with the turn knobs. The knobs would be included with your Inno roof mounted carrier. | Hi! Can you please tell me if...

Trying to either find locking knobs for the specific threading I’ve seen them for bike racks, but no published thread specs or finding replacement hardware to match the thread requirement on locking knobs. ...

How it works is that you use the knob that is in the hitch pin area to secure it to the hitch and then using the anti-rattle knob that is more towards the rear of the carrier you are pinning the carrier to the hitch tube. |

The Tire Hold # INH120 is locked into the hitch and won't fall or be pulled off due to the tensioning hand knob at the front. After you tighten it in the hitch, which expands the shank, you lock the knob, and what this does is prevent the knob from being utilized. |

Is this knob the ground connection or what is the difference between the adapators that do or dont have this knob? | I have a 2003 4 Runner with tow package the factory hitch connection is 7 flat. I have a...

To level the sensor, you will set the power knob to maximum by fully rotating it clockwise (with the trailer connected). | Light on controller goes from green to a light green. No assist. Will not adjust with the riflght diel....

Hi Victor; are you referring to the knob marked with an arrow in the picture below? You can reach out to Inno and might have some luck with them sending just the knob. | Hello, i have an Inno fairing and i...

The Inno Feet, part # INSU-K5 come with the locking hand knobs and includes 2 keys as well. | hello, I have a 2009 Dodge Caliber SXT and am interested in the Inno Square Bar Roof Rack. I would like to purchase the locking hand...

I made you a short video that shows how to replace the knob provided that the little tabs on the back of the knob or where they mount are not damaged. | While installing and checking operation, as I activated...

You are going to want the Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional # RED52VR, don't forget to grab a Universal Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob # 331-TPSI-001 for one of those empty spots on your dash. |

As a test I held the P2 at no upward angle in my hand and applied the manual power knob, with no increase / improvement in braking power. | Hello eTrailer. I recently installed the Prodigy P2 Brake Controller on my 2017...

In addition to the locking hand knob that secures the rack to the hitch/vehicle, this carrier also has an integrated cable lock to secure the bikes to the rack. | Hello, Does this rack lock to the hitch? I saw a review on another...

Check to be sure that the power knob is not set all the way to the lowest position. | I just hook up a pilot controller and if i hit the break pedal the dot in the middle lights up, but if i use the button on the controller...

Now for installing the knob of the controller you will need to pick a spot that you have at least 3/4" clearance for the knob, and 1-3/4" space behind the location for the back part of the knob to have enough clearance. |

It has a manual slide, a power knob on the right and another knob on the left. | Its a Journey model # 527408045 approx. 7 yrs. old. I lost my manual and want to set it up for a new trailer. Is there a manual...

Also no lights on the control knob! | How do you make the brake controller think it is connected to a trailer with brakes? Just to make the unit light up. I have no lights on the control knob. I do lights on the tester for...

Then rotate the Level Knob clockwise until you see a shade of orange on the light. | I have the four wires hooked up, have power to the controller. But it doesnt go from green to orange/red when I try leveling the sensor....

The main unit measures 3-3/8" long x 3-15/16" wide x 1-1/8" tall and the control knob measures 2-3/8" long x 3/4" wide x 7/8" tall. | Im interested in Redarc Tow-Pro Elite # RED44FR because the control can be hidden and placed...

This is with the power knob all the way clockwise. Thanks | My green light looks like its on with trailer disconnected but when my trailer is connected the green light is much brighter. Also, I was trying to adjust my level...

WHEN CONNECTED TO VAN GREEN LIGHT IS ON WHEN EMEGENCY BRAKE IS APPLIED ,LIGHT TURNS RED WHEN FOOT BRAKE IS APPLIED LIGHT STAYS GREEN NO MATTER WHERE THE POWER KNOB OR LEVEL KNOB IS. WHAT IS THE PROBLEM? | WHEN...